M4 RGBW CONFIGURATION 12-24V DC, DMX Data +, DMX Data Data Shield SPECIFICATIONS Input Power Consumption 4.5W per luminaire maximum (all 4 colours at 100%) Light Engine Plug-In dimmable module equipped with a high power Cree 4x1 watt RGBW LED Cabling Special hybrid cable comprising of: EIA-485 (aka RS-485) complaint 120 Ohm twisted pair with drain wire in a foil shield. A pair of marine grade tinned 0.75mm2 DC power conductors Standards IP68, LM79, CE, USITT DMX512-A Beam (FWHM) Spot (20°), Medium (34°) and Oval (48°+24°) Cable Length 3 meters (10ft) Standard - (Custom lengths can be specified at an additional charge) Lens Cover Clear glass, frosted glass Colours Neutral White 4000°k, Red, Green and Blue Max Run Length Cabling between the DMX signal controller and the last luminaire must not exceed 200m. Max Number Bussed The input impedance of 12K Ohms restricts the maximum number of luminaires to 32 on a bussed network Addressability All luminaires have the default address of 1. Please note that fixtures are not individually addressable. Warranty Electronics Warranty 3 Years Body Warranty 5 years Aluminium. 10 years Copper and Stainless Steel Copyright 2018 LuxR Limited - V2 May 2018

REPLACING COMPONENTS There are a number of features that make the LuxR solution unique: Firstly remove the luminaire from its recessed location. Unscrew the flange paying close attention to the assembly order or refer to the diagram below. Locate the item that needs to be replaced, it is imperative you replace the component with factory LuxR parts to ensure correct operation of the luminaire. When reassembling make sure all the components are in their correct order to ensure water tightness and correct light output. - The DMX ‘dimmer’ driver is integrated into the luminaire itself. - There is...

M4 RGBW UPLIGHTER DIMENSIONS M4 RGBW LOUVRE DIMENSIONS

M4 RGBW STEPLIIGHT DIMENSIONS M4 RGBW PATHLIGHT DIMENSIONS M4 RGBW SQUARELIGHT DIMENSIONS