LED50 GEN2
1Pages

Lucent LED50 Range Lucent's own range of 50mm diameter LED modules including the LED50 >80CRI and LED50-PLUS >90CRI, LED50-SEVEN, LED50-Ambiance Warm Dim, all utilising Cree XP-E2 white LED's, and LED50-ONE based on Citizen COB technology. Please refer to luminaire Specification sheet for maximum lumen output that can be used within the fixture. LED50 module, RA > 80CRI using 9 x Cree XP-E2 LEDs A choice of 3 colour temperatures 2700/3000/4000K & 3 Optic angles 18/22/36°. Max Drive current 500mA, can be under run if required. Dimmable with correct driver type. For dimming protocols available please consult Lucent Lighting. Module with on-board protection against surge and reverse polarity. LED50 Plus module, RA > 90CRI using 9 x Cree XP-E2 LEDs A choice of 2 colour temperatures 2700/3000 & 3 Optic angles 18/22/36°. LED50 current Gen 2can be under run if required. Dimmable with Plus 500mA, 90CRI Module Max Drive correct driver type. For dimming protocols available please consult Lucent Lighting. Module with on-board protection against surge and reverse polarity. LED50 SEVEN 80CRI Module LED50 Spot module, RA > 80CRI using 7 x Cree XP-E2 LEDs A choice of 3 colour temperatures 2700/3000/4000K in a narrow 12° spot optic and 2 complimentary optics. Max Drive current 700mA, can be under run if required. Dimmable with correct driver type. For dimming protocols available please consult Lucent Lighting. LED50 Seven Order Code LED Colour LED50 Ambiance Warm Dim, RA > 80CRI using 6 x Cree XP-E2 & 1 x XT-E LEDs A choice of 2 main colour temperatures 2700/3000 dimming to 2200K. Available in 3 optic angles 19/22/36° Drive current 700mA, Dimmable with correct driver type. For dimming protocols available please consult Lucent Lighting. LED50 ONE 80CRI Module LED50 ONE, RA > 80CRI using 1 x Citizen COB LED. A choice of 3 colour temperatures 2700/3000/4000K with a single optic in two beam angles 24/38°. Max Drive current 350mA, can be under run if required. Dimmable with correct driver type. For dimming protocols available please consult Lucent Lighting. * Separate die cast plaster in kit for plaster ceilings. ** Tested from ceiling underside. To specify IP54; add '-IP' to end of code. It is Dimming options depend on driver (to be separately and therefore reserve the *** the policy of Lucent Lighting to continually review and improve its productsordered/specified). right to change any details of product or withdraw specifications without prior notice. Some control methods may require additional cabling Luminaires designed to comply with EN60598 and all other relevant Standards. This Specification Sheet supersedes all previous versions All intellectual property rights to change any details, dimensions colours etc without prior notice. Lucent reserve the right pertaining to the product described above and to this document are owned by or licensed to Lucent Lighting UK Ltd. We reserve our right to take whatever action is necessary to protect those intellectual property rights. Please notify Lucent Lighting Ltd of any inaccuracies immediately. E&OE Job/Project Name Contact Lucent Lighting: e: info@lucent-lighting.com t: +44 (0)20 8442 0880