Catalogs >
LITOKOL >
SpazioLamina EVO Perlato

SpazioLamina EVO Perlato
1 / 5Pages

Catalog excerpts

SpazioLamina EVO #Perlato THREE-COMPONENT DECORATIVE RESIN FOR FLOORS AND WALLS. SUITABLE FOR OVERLAYING AND UNDERFLOOR HEATING. FOR INTERIORS. PRODUCT WITH VERY LOW VOLATILE ORGANIC COMPOUND EMISSION RATE. Wall & Floor SpazioLamina EVO #Perlato is a flexible, water-based decorative system characterised by a particularly smooth spatula effect finish, with metallic and pearlescent effect. ADVANTAGES / FEATURES • Product with very low volatile organic compound (VOC) emission rate, compliant with class A+ (Émission dans l’air intérieur – French Regulations) • Suitable for installation on heating screeds • Suitable for overlaying on existing flooring • Extended workability of mix (about 40 minutes), which facilitates application on large surfaces • Product exempt from restrictions for road, sea, air and rail transport • Water-based product • Product with excellent fluidity and easy to spread • Easy to sand • Smooth surface with metallic effect • Excellent resistance to wear • Available in six different colours obtained using prestigious pearlescent powders: Ambra, Bianco, Grigio, Nero, Ocra, Tabacco Bucket part A: 2.00 kg + Can part B: 0.46 kg + Can part C: 0.30 kg) = Total 2.76 kg Intended uses Interiors Floors and walls Underfloor heating Overlaying on existing floors and coverings in ceramic, porcelain stoneware, mosaics, agglomerates, natural stones Residential, public, commercial building Indoor wet areas (bathrooms, shower enclosures) Covering of furniture and structures in wood, metal or plastic 12 hours after the application of Multifondo EVO, it can be sanded with 60-80 grit sandpaper. After carefully vacuuming any dust, proceed to apply the texture. In any case, the respective technical data sheets must be consulted for correct use of the indicated products. Suitable substrates - Multifondo EVO on: Cement screeds Self-levellers Skim coats Lightweight panels (such as WEDI-SCHLUETER). Separation membrane Underfloor heating systems Concrete Normal and waterproof gypsum Fibre cement slabs (such as Aquapanel) Gypsum and anhydrite Existing floors and coverings in ceramic, porcelain stoneware, mosaics, agglomerates, natural stones and wood Rough cement plaster Wood panels Metal Smooth

Open the catalog to page 1

RESIN DECORATIVE SYSTEM PLANNING The only way to guarantee the long-lasting performance of resin decorative systems is to properly plan the process. It is therefore advisable to consult the national regulations in force in each country, for example standard UNI 10966 for Italy, which defines the planning and installation criteria for resinous systems for interior and exterior horizontal and vertical surfaces. Some of the general precautions that need to be followed are listed below as an example. ANALYSIS OF SUBSTRATE Vapour barrier/retarder Make sure the vapour barrier or retarder has been...

Open the catalog to page 2

Mix, preferably using an electric drill with mixing paddle at low speed (≈ 300/min.) until a consistent mix is obtained without lumps. Hand mixing is not recommended. The three components are pre-batched in their packaging, thus preventing mixing errors. Add 5% water to the mix and finish mixing. For small surfaces, the components can be partially mixed to avoid unnecessary waste. In these cases it is advisable to use a precision scale and to mix the components in accordance with the mixing ratio. In ambient conditions nearing the application limits (very warm or very cold climates), a...

Open the catalog to page 3

actually be used within this period of time • Application of the product in environments with relative humidity greater than 80% is not recommended • If the ambient temperature needs to be increased, use only electric heaters and not fired heaters (which may cause the emergence of surface defects) • The temperature of the substrate must be at least 3°C higher than the dew point • Applicable only on substrates prepared and levelled with Multifondo EVO • During the winter, setting times may be significantly longer, therefore check that the surface of the coat is not sticky before any further...

Open the catalog to page 4

Powered by TCPDF (www.tcpdf.org) COLOUR CHART Data detection at temperature +23 °C, R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. The different textures of the Spaziocontinuo® surfaces have different colours, saturation and brightness. For each project, use materials from a single production batch. Materials from different batches may assume slightly different colours. The texture of Spaziocontinuo® is characterised by material discontinuity and natural irregularity, achieved through the skilful artisan work of the installer, thus making...

Open the catalog to page 5

SpazioLamina EVO Perlato 1 / 5Pages

Catalog excerpts

All LITOKOL catalogs and technical brochures

SpazioLamina EVO Perlato
1 / 5Pages