Wall & Floor SpazioChiaroscuro EVO READY-TO-USE WATER-BASED DECORATIVE SYSTEM FOR WALLS. SUITABLE FOR OVERLAYING. FOR INTERIORS. PRODUCT WITH VERY LOW VOLATILE ORGANIC COMPOUND EMISSION RATE. Synthetic resin-based decorative system in aqueous dispersion, ready to use and extremely easy to apply. Allows the creation of chiaroscuro effects with a soft texture. ADVANTAGES / FEATURES • Product with very low volatile organic compound (VOC) emission rate, compliant with class A+ (Émission dans l’air intérieur – French Regulations) • Water-based product • Easy to sand • Product with excellent fluidity and easy to spread • Product exempt from restrictions for road, sea, air and rail transport • Ready-to-use product • The system can be applied to a broad range of substrates and also overlaid on existing coverings • Smooth finish • Allows the creation of exclusive chiaroscuro effects with a soft and delicate texture • Available in the 27 nuances designed by Rinaldo Rinaldi for the Spaziocontinuo® palette, and on request in any colour of the international NCS and RAL colour charts • Self-polishing texture: once dried, it can be rubbed with a white felt to increase its shine and chiaroscuro effect; it can also be polished by “smoothing” with a stainless steel trowel (Stainless Steel Trowel 20x8 art. 201T0001) about 20-30 minutes after application • Extremely economical decorative system due to high product yield • Compliant with harmonised European standard UNI EN 15824 Intended uses Interiors Walls Overlaying on existing coverings in ceramic, porcelain stoneware, mosaic, agglomerates, natural stones Covering of furniture and structures in wood, metal or plastic Residential, public, commercial building Indoor wet areas (bathrooms, shower enclosures) Suitable substrates RasanteParete/Ceramica EVO on: Rough cement plaster Washable paints (temperas need to be removed) Skim coats Cement plasters with fine mortar finish Gypsum-based plasters or smoothers Underfloor heating systems Smooth cement panels Normal and waterproof gypsum Fibre cement slabs (such as Aquapanel) Existing coverings in ceramic, porcelain stoneware, mosaic and natural stone Lightweight panels (such

DECORATIVE SYSTEM PLANNING The only way to guarantee the long-lasting performance of resin decorative systems is to properly plan the process. It is therefore advisable to consult the national regulations in force in each country, for example standard UNI 10966 for Italy, which defines the planning and installation criteria for resinous systems for interior and exterior horizontal and vertical surfaces. Some of the general precautions that need to be followed are listed below as an example. ANALYSIS OF SUBSTRATE Curing In order to be considered dimensionally stable, a substrate must be sufficiently...

Each time the decorative system is applied in a wet environment, certain precautions are necessary: - If covering a niche inside a shower enclosure, check that the slope is sufficient to prevent any water build-up. - if there is a pre-existing waterproofing system, check that it is cementitious (e.g. Coverflex and Elastocem), applied with a smooth trowel (do not apply on ready-to-use and/or roller-applied waterproofing systems); in any case, a waterproofing system is not necessary insofar as this function is performed by these resin systems, if applied correctly. - in case of slight rising damp,...

Powered by TCPDF (www.tcpdf.org) Compliance Adhesion to substrate Resistance to UV rays Resistance to humidity Resistance to temperature fluctuations Resistance to ageing 1.5 MPa ≥ 0.3 MPa Excellent Excellent Excellent Excellent COLOUR CHART Data detection at temperature +23 °C, R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. The different textures of the Spaziocontinuo® surfaces have different colours, saturation and brightness. For each project, use materials from a single production batch. Materials from different batches may assume slightly...