Primer X94 INSULATING PRIMER IN AQUEOUS DISPERSION FOR GYPSUM- AND ANHYDRITEBASED SUBSTRATES. FOR INTERIORS. READY TO USE. Synthetic resin-based primer in aqueous dispersion. The product is colored to facilitate the identification of treated areas. ADVANTAGES / FEATURES 5 kg (11lb) cans - 600 kg (1,322.7lb) standard pallet 10 kg (22lb) (cans - 600 kg (1,322.7lb) standard pallet Suitable for the insulation of gypsum-based surfaces before the installation of ceramic and porcelain tiles with cementitious adhesives. Also suitable as a base coat before applying gypsum-based plasters, skim coats, cementitious smoothers on absorbent substrates such as: cellular concrete, concrete, bricks. The substrates must be clean, solid, compact, crack-free, properly cured and without rising damp. Cement, lime, gypsum residue or old binders can be mechanically removed by sanding, abrasion or using other suitable techniques. Anhydrite floors must be previously sanded and therefore dusted. Use a hygrometer to check that the residual humidity is not greater than 0.5% in the case of gypsum-based plasters or substrates. Ready-to-use product without the need for any preparation. If the primer is used as an insulator for the installation of ceramic and porcelain tiles with cementitious adhesives, the package needs to be shaken before use and the product applied undiluted on the gypsum-based substrate. After the drying time, the tiles can be installed. Se il prodotto viene impiegato come mano di ancoraggio per intonaci a base gesso, rasanti, ecc, deve essere diluito con acqua in rapporto 1:1 oppure 1:2 a seconda dell’assorbimento del supporto. Once fully dried, application can proceed. In the case of high absorbency rates, repeat the operation a second time. The product can be evenly applied with a brush or roller across the entire surface. Depending on the absorbency of the substrate, the product can be applied either pure or diluted with water to a ratio of 1:1 or 1:2. On low porosity and low absorbency substrates, apply the product diluted, while for high porosity and high absorbency products, apply the product pure. Ready to use Consolidates the surface of the substrate Reduces the surface absorption of the substrate Increases the pot life of plasters and avoids cracking phenomena caused by shrinkage Increased adhesion of various types of coverings (paints, plasters, wallpapers, tiles, etc.) Prevents the chemical reaction between the gypsum and cement in tile adhesives responsible for the formation of a salt called “ettringite”, which is the main cause of detachment of ceramic and porcelain tiles from gypsum-based substrates Special Products

The thickness of the impregnated substrate is roughly 1 mm (0.039in) per 200 ml (0.053US gal lqd) of product applied to each square meter. Wait for the product to completely dry before moving on to the next steps (bonding, leveling, skimming). At a temperature of about 73.4°F (+23°C) approximately 4 hours are necessary for complete drying. Low temperatures will delay the film-forming time, high temperatures will shorten it. • Spread the product at temperatures between 40°F and 95°F • Since the product is based on synthetic resins in aqueous dispersion, it must be protected against frost. When...

Powered by TCPDF (www.tcpdf.org) Form n. 503 Revision n. 3 Date: January 2021 The information and provisions contained in this technical data sheet reflect our best experience. Given the impossibility of directly intervening on the conditions of the work site and execution of the works, they represent indications of a general nature, which are in no way binding on our Company. It is therefore advisable to perform a spot test to check the suitability of the product for the intended use. In any case, users must determine whether or not it is suitable for the intended use and shall assume all associated...