Primer C CONSOLIDATING AND INSULATING PRIMER IN AQUEOUS DISPERSION. READY TO USE. ZHERORISK TECHNOLOGY OFFERS VERY LOW VOLATILE ORGANIC COMPOUND EMISSION RATE. Fixative comprised of a micro-emulsion made from synthetic resins in aqueous dispersion, featuring high penetration on porous substrates such as: cement and anhydride screeds, cement- and gypsum-based plasters, gypsum paneling, etc. ADVANTAGES / FEATURES • Ready to use • Easy and fast application • Solvent-free, odorless product 5 kg (11lb) cans - 600 kg (1,322.7lb) standard pallet 10 kg (22lb) (cans - 600 kg (1,322.7lb) standard pallet Suitable for the consolidation of powdery and incoherent surfaces of screeds and cement plasters. Suitable as an insulating primer for gypsum-based, anhydride and similar substrates, before applying cementitious adhesives for the installation of ceramic and porcelain tiles. Base coat for subsequent applications of cementitious self-levelers or skim coats to favor the fluidity of the mix, thus improving adhesion. The substrates must be clean, solid, compact, crack-free, properly cured and without rising damp. Cement, lime, gypsum residue or old binders can be mechanically removed by sanding, abrasion or using other suitable techniques. Anhydrite floors must be previously sanded and therefore dusted. Use a hygrometer to check that the residual humidity is not greater than 0.5% in the case of gypsum-based plasters or substrates. The product can be evenly applied with a brush or roller across the entire surface. Depending on the absorbency of the substrate, the product can be applied either pure or diluted with water to a ratio of 1:1 or 1:2. On low porosity and low absorbency substrates, apply the product diluted, while for high porosity and high absorbency products, apply the product pure. The thickness of the impregnated substrate is roughly 1 mm (0.039in) per 200 ml (0.053US gal lqd) of product applied to each square meter. Wait for the product to completely dry before moving on to the next steps (bonding, leveling, skimming). At a temperature of about 73.4°F (+23°C) approximately 4 hours are necessary for complete drying. Low temperatures will lengthen the setting time, high temperatures will shorten it. • Spread the product at temperatures between 50°F and 95°F • Since the product is based on synthetic resins in aqueous dispersion, it must be protected against frost. When packages are transferred and stored in a warehouse, the temperature must not fall below 40 °F (+5°C) so as not to compromise the quality of the product • Before application, use a hygrometer to check that the residual humidity in the substrate is no more than 0.5% for gypsum-based substrates Special Produc

Powered by TCPDF (www.tcpdf.org) All substrate should be structurally sound, stable, dry, clean and free of any substance that may inhibit adhesion In warm climates, keep the packaged product in a cool and dry place away from the sun before use Do not use the product on metal sheeting Do not use on non-absorbent surfaces Do not use the product on magnesium substrates Do not use the product for applications not stated in this technical sheet If in doubt, contact the Litokol S.p.A Technical Help Service. SAFETY INFORMATION Consult the product safety data sheet, available on request. PRODUCT FOR...