Litostick X35 HOT MELT GLUE STICKS FOR CERAMIC SAMPLES Yellow hot melt glue sticks. 11lb (5 kg) boxes (boxes with 500 pcs) - 1,322.7lb (600 kg) standard pallet of 120 boxes Used to glue ceramic and porcelain tiles in sample displays and showrooms. Litostick X35, thanks to its strong adhesive power, is expressly recommended for the application of non-absorbent materials such as: single fired tiles, clinkers, porcelain stoneware. PREPARATION OF SUBSTRATES APPLICATION The substrates must be clean, solid, compact, crack-free, properly cured and without rising damp. SAFETY INFORMATION Consult the product safety data sheet, available on request. PRODUCT FOR PROFESSIONAL USE IDENTIFICATION DATA Color Diameter Length Specific gravity Melting point Open time Shelf life Data detection at temperature +73.4°F (+23 °C ), R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. Using the electric gun, extrude the hot product and apply it in dabs on the back of the tile, in line with any feet. Apply the tile immediately, pressing firmly for a few seconds to further increase the product’s adhesion capacity. Within a few minutes, the product will have dried and the parts will be permanently fixed. Spread the product at temperatures between 50°F and 95°F All substrate should be structurally sound, stable, dry, clean and free of any substance that may inhibit adhesion Do not use the product for applications not stated in this technical sheet If in doubt, contact the Litokol S.p.A Technical Help Service. Special Products Yellow 12 mm (0.47in) 120 mm (4.7in) 7.5lb/gal (0.9 kg/dm3) 356 - 374°F (180 - 190°C) 30 seconds Unlimited in original packaging in a dry place

Powered by TCPDF (www.tcpdf.org) Form n. 511 Revision n. 2 Date: January 2021 The information and provisions contained in this technical data sheet reflect our best experience. Given the impossibility of directly intervening on the conditions of the work site and execution of the works, they represent indications of a general nature, which are in no way binding on our Company. It is therefore advisable to perform a spot test to check the suitability of the product for the intended use. In any case, users must determine whether or not it is suitable for the intended use and shall assume all associated...