Litoside SELF-ADHESIVE BAND IN EXPANDED POLYETHYLENE FOR PERIMETER SEPARATION JOINTS. Gray expanded polyethylene band. ADVANTAGES / FEATURES • Totally non-absorbent of water • Retains its features unaltered over time • Compressible and elastic Suitable for the development of perimeter separation joints on interior and exterior floors before laying screeds. The substrates must be clean, solid, compact, crack-free, properly cured and without rising damp. It is recommended to pre-clean the surface with a vacuum cleaner having a suitably sized spout. Unroll the LITOSIDE band and lay it along the entire perimeter of the walls in the room, and on any elevations such as: columns, stairs, etc. The band must be attached to the walls, removing the white liner by applying slight pressure. Any vapor barrier made from polyethylene sheets or similar must be turned up on the Litoside bands for the entire thickness of the screed. After the installation of the floor covering (ceramic and porcelain tiles, natural stones, wood flooring, etc.), the band must be trimmed at the finished floor height. The perimeter joint will be subsequently covered by the skirting board or other coverings. • The size of the joints is defined according to the intended use of the tiled surface, its location and intended movements • If the perimeter separation joint needs to be thickened, it is possible to overlap two Litoside bands to obtain a thickness of 10 mm (0.39in) • Do not use the product for applications not stated in this technical sheet • If in doubt, contact the Litokol S.p.A Technical Help Service. SAFETY INFORMATION Based on European Regulations (Reg. 1907/2006/EC - REACH) the product is considered an article and therefore does not require safety data sheets. PRODUCT FOR PROFESSIONAL USE IDENTIFICATION DATA Color Height Thickness Specific gravity Customs code Longitudinal elongation at break (IASTM 0638M) Special Products

Powered by TCPDF (www.tcpdf.org) Stress at break (ASTM 0638M) Water absorption (ASTM C272) Water vapor permeability (ASTM E96) Serviceability Temperatures Shelf life 2.3 kg/dm3 (5.07lb/in3) 0.42% 7.95 g/m2 (0.28oz/yd2) 24 hours From -22°F to +194°F (-30°C to +90°C) Unlimited in original packaging in a dry place Data detection at temperature +73.4°F (+23 °C ), R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. Form n. 519 Revision n. 1 Date: January 2021 The information and provisions contained in this technical data sheet reflect our best experience....