Litoscrub EVO CONCENTRATED NEUTRAL WATER-BASED LIQUID WAX REMOVER FOR REMOVAL OF WAX, RESINS, POLYMERS, DIRT AND PRE-EXISTING TREATMENTS BEFORE OVERLAYING. ALSO EFFECTIVE FOR THE DEEP CLEANING OF TOUGH DIRT. Litoscrub EVO is a water-based, highly concentrated wax removal and degreasing liquid suitable for the removal of wax, natural or synthetic polymers from any interior or exterior floor before overlaying. 1.05 qts. (1 l) bottles (boxes with 12 pcs) Used pure or diluted to approximately 50% in water (1 part product in 1 part water), it is suitable as a deep wax remover and to remove stubborn residue before installation with an adhesive. Diluted to 25% in water (1 part product in 3 parts water), it is suitable as a degreasing detergent for routine maintenance and cleaning of floors. Effective in removing algae, mold and efflorescence on absorbent materials such as fired tiles and terracotta. Shake well before use. Before removing the wax with Litoscrub EVO, any dust or surface debris must be removed. It is recommended to apply the material on one small section of surface at a time. Litoscrub EVO can be used pure or diluted in clean water, depending on the nature of the dirt to be removed. Once suitably diluted, pour the product onto the surface, spreading it evenly with white felt or a single disc machine. Let Litoscrub EVO work for about 5-10 minutes, mechanically rubbing it with felt or a single disc machine at regular intervals. In case of application on very absorbent surfaces, it may be necessary to pour extra product on the surface to replace that absorbed by the material. Once the indicated time has elapsed, pour a sufficient amount of clean water and re-emulsify the solution on the floor, spread it evenly and remove any residue using a liquid vacuum cleaner, rags or paper towel. After removing the residue, rinse the surface with plenty of clean water. Wait for complete drying before opening the area to traffic or before installation with an adhesive. For installation, it is recommended to use improved cementitious adhesives in class C2 according to EN 12004, such as Litoflex Pro K80, Powerflex K50, Superflex K77, Hyperflex K100 or the reactive adhesive Litoelastic EVO in class R2T according to EN 12004. Excellent wax removal power Avoids the use of materials that are hazardous and difficult to procure, such as caustic soda Allows direct application with cementitious adhesives in the case of overlaid installations Versatile product, can be used on all surfaces Completely removes old wax or pre-existing treatments No restrictions for transport over road, sea, air and rail Effective on plant efflorescence, algae and mold Pleasant fragrance

Powered by TCPDF (www.tcpdf.org) • Spread the product at temperatures between 40°F and 95°F • Wear protective clothing during handling. Follow the instructions shown on the label and safety sheet • Before use, protect doors, windows, rubber gaskets, furniture, taps and fittings, metal or PVC profiles and all surfaces that may be damaged by direct contact with the detergents • Before applying the product, it is advisable to perform a spot test to check its suitability for the intended use • In the case of accidental leaks, soak up the product using an absorbent material (paper, sawdust, vermiculite,...