Catalogs >
LITOKOL >
Idrokol X20

Idrokol X20
1 / 3Pages

Catalog excerpts

Idrokol X20 SYNTHETIC RESIN-BASED LATEX IN AQUEOUS DISPERSION ADHESION AID FOR CEMENTITIOUS MORTARS. FOR INTERIORS AND EXTERIORS. Synthetic resin-based latex in aqueous dispersion, solvent-free. The product is a low viscosity white liquid with high resistance to alkaline saponification. ADVANTAGES / FEATURES 5 kg (11lb) cans - 600 kg (1,322.7lb) standard pallet 10 kg (22lb) (cans - 600 kg (1,322.7lb) standard pallet 20 kg (44lb) cans - 720 kg (1,587.3lb) standard pallet Particularly versatile additive that can be used in numerous applications. Additive for cementitious mortars such as screeds, plasters, leveling layers to improve adhesion properties and mechanical strength. Additive to develop bonding slurries for bonded screeds made with Litocem Pronto / Litocem or Portland cement on existing substrates. Additive to develop bonding slurries for fresh concrete castings over existing concrete. Additive to be mixed with cementitious adhesives to improve adhesion properties. The substrates must be clean, solid, compact, crack-free, properly cured and without rising damp. Cement, lime, gypsum residue or old binders can be mechanically removed by sanding, abrasion or using other suitable techniques. Solvent-free, odorless product Easy and fast application Reduced consumption Also suitable for outdoor paving Idrokol X20 water cement ADDITIVE FOR leveling ADDITIVE FOR LAYERS UP TO 10 mm PLASTERS (0.39in) 30 kg (66lb) Idrokol X20 1 part Idrokol X20 1 part 264.5 lb water 1 part water 4 parts (120 kg) 300 kg cement 4 parts cement 5 parts (661.3lb) 1 m3 fine sand 4 parts aggregates 15 parts (1.1yd3) Special Products ADDITIVE FOR BONDING SLURRIES Idrokol X20 1 part water 1 part cement or Litocem ADDITIVE FOR CEMENTITIOUS ADHESIVES Adhesive 44lb (20 kg) Idrokol X20 2 kg (4.4lb) water

Open the catalog to page 1

For all types of mixes, it is recommended to mix the additive with the water first before batching the other powder components, in respect of the indicated quantities. Mixes can be prepared using a cement mixer, grout mixer or electric drill with mixing paddle. In any case, it is advisable not to exceed the mixing times to avoid entraining too much air. In case of low thickness leveling layers or bonded screeds, before casting it is essential to apply the bonding slurry constituted by Idrokol X20-water-cement onto the existing substrate, batched in equal parts (1:1:1). The bonding slurry...

Open the catalog to page 2

Powered by TCPDF (www.tcpdf.org) Data detection at temperature +73.4°F (+23 °C ), R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. Form n. 502 Revision n. 2 Date: January 2021 The information and provisions contained in this technical data sheet reflect our best experience. Given the impossibility of directly intervening on the conditions of the work site and execution of the works, they represent indications of a general nature, which are in no way binding on our Company. It is therefore advisable to perform a spot test to check the...

Open the catalog to page 3

Idrokol X20 1 / 3Pages

Catalog excerpts

All LITOKOL catalogs and technical brochures

Idrokol X20
1 / 3Pages