FillCleaner EVO ECOLOGICAL DETERGENT FOR THE REMOVAL OF RESIDUE LEFT BY GROUTING PERFORMED WITH FILLGOOD EVO, THE SINGLE COMPONENT, READY-TO-USE, WATER-BASED POLYURETHANE GROUT. FillCleaner EVO is an ecological detergent with neutral pH, delicate on ceramic surfaces, comprised of ingredients derived from natural, completely biodegradable substances. 0.8 qts. (0.75 l) spray bottles (boxes with 12 pcs) FillCleaner EVO is the specific cleaner used to remove resinous residue left by grouting performed using the polymer mortar for joints, FillGood EVO, from the surface of tiles and vitreous mosaics. Its high viscosity makes it also perfect for wall applications with no dripping. The product is very efficient on surface residue without damaging the polymer mortar used in the joints. FillCleaner EVO is also perfect as a degreaser for ceramic surfaces in contact with foodstuffs, such as kitchen countertops. Shake well before use. For the removal of any FillGood EVO halos, the detergent must be applied once the grouting has sufficiently set (normally after 24 hours at a temperature of +20/+25°C (+68/+77°F)). For fresh residue the product requires less time to work, while for more consolidated residue, the product will need to be left in contact for longer. Spread the pure product on the surface and let it work for a few minutes. Then rub the surface with white felt (art. 109GBNC). FillCleaner EVO should be applied gradually in sections with a limited area (about 1-2 m2 (1.09 - 2.19yd2) so as not to leave it in contact with the grouting for more than 5 minutes. It is recommended to mechanically rub the product when applied to facilitate its removal. Collect the cleaning solution with a damp sponge and dry the surface with a clean rag or cloth. Do not wait for the rinse water to evaporate as this may cause halos to reappear on the surface. If polyurethane residue can still be seen after rinsing, repeat the application following the same procedure. SAFETY INFORMATION Consult the product safety data sheet, available on request. PRODUCT FOR PROFESSIONAL USE Water-based product Excellent cleaning power Pleasant fragrance Non-aggressive solution, which can also be used on polished marble and honed or polished stoneware without the risk of corrosion or tarnishing • Exempt from hazard classification for transport Spread the product at temperatures between 40°F and 90°F Use the product pure, undiluted FillCleaner EVO must be used to clean after at least 24 hours from grouting with FillGood EVO Change the rinse water frequently Do not use the product for applications not stated in this technical sheet If in doubt, contact the Litokol S.p.A Technical Help Service.

Powered by TCPDF (www.tcpdf.org) IDENTIFICATION DATA Appearance Color Odor Customs code Shelf life Clear dense liquid Colorless Feature 34029090 24 months in original packaging away from sources of heat and direct sunlight. Protect against frost. APPLICATION DATA Treatment time Flammable pH Specific gravity Application Acceptable application temperatures Consumption Data detection at temperature +73.4°F (+23 °C ), R.H. 50% and with no wind. May vary depending on the specific conditions of the installation site. Form n. 321 Revision n. 3 Date: January 2021 The information and provisions contained...