INFORMATION SHEET Listone Giordano Marine INFORMATION SHEET Listone Giordano Marine is a real two-layer glued down hardwood floor suitable Margaritelli S.p.A. – Fraz. Miralduolo 06089 Torgiano - Perugia - Italy - Tel. +39.075.988.681 Fax +39.075.988.90.43 - [email protected] - www.listonegiordano.com

Listone Giordano for outdoor application. It integrates a number of patented technologies which are the result of Listone Giordano research and experience in the field of two-layer wood flooring with birch support. With Listone Giordano Marine you can install an outdoor hardwood floor having the same aesthetic features and underfoot feel as a Listone Giordano indoor floor. Listone Giordano Marine can be also installed indoors, thus allowing you to create seamless surfaces between the inside and outside of a house. As this solution, unlike raised decks, has no gap below the floor and no interspace...

INFORMATION SHEET Listone Giordano GLUED-DOWN TOP-SUPPORT OUTNUTURE A high-resistance vegetable oil based finish for outdoors that nourishes the wood in-depth, creating a total protective barrier against ageing and cracking. OUTNATURE does not require sanding during maintenance. After finishing installation of Listone Giordano Marine, apply a final coat of non-slip oil for decking in order to further strengthen the surface protection of the floor, to make it even more slick and deliver it in excellent condition to the client. UNFINISHED WOOD Decking boards are supplied in unfinished wood with...

INFORMATION SHEET The actual durability of a manufactured product on the outside, however, also depends on the constructive features and the conditions in which it is placed in operation. Listone Giordano Marine draws its high durability both from the natural ability of the wood (in the case of Teak class I durability) and from the special installation that also helps preserve the support wood (which does not have the same durability qualities as that of Teak). For this new and revolutionary use of Listone Giordano Marine, parquet which has up to now been considered exclusively for indoor use,...

INFORMATION SHEET • Surface planarity check: Place a 2 m long straight-edge on the subfloor and make sure that there are no more than 2-3 mm slopes. This verification must also be made in case of pre-existing hard flooring. The slope of the subfloor, which must be present for required rainfall drainage, should not be considered in this check. • Structural solidity check: No cracks or in-depth dents should be created when you hit the surface of the screed with a hammer. • Surface compactness check: No deep grooves should be created and no dust created when you scrape the tip of a nail on the surface....

INFORMATION SHEET On the large terraces or other surfaces, you can find a subdivision of the area in various sectors with different slopes. These may have conditions similar to those of the graphs that follow, which only represent an example from which to draw appropriate assessments for any other construction situation that may arise. Margaritelli S.p.A. – Fraz. Miralduolo 06089 Torgiano - Perugia - Italy - Tel. +39.075.988.681 Fax +39.075.988.90.43 - [email protected] - www.listonegiordano.com

Listone Giordano The best collection of rainfall precipitations can be achieved through continuous grilles, able to collect and dispose at any point on the flooring. Proper installation is expressed by the image here to the side. It is however also possible to provide individual grilles on catch basins positioned at points where the installation bed slopes are conveyed. Never set flooring on changes of subfloor slopes without setting an expansion joint (to then be sealed) in perfect projection of the change of slope itself. In the absence of this break with the expansion joint, the boards would...

Listone Giordano 1 pc every 4 linear metres of joint without base cord NECESSARY EQUIPMENT Suitable roller for primer application (type for enamels and resins) Brush suitable for primer application on points where roller cannot reach Brush for finishing oil application Spray gun for sealant draught excluder extrusion PREPARATION OF CONCRETE SUBFLOORS (SCREEDS) 1ST STEP Application of a first coat of primer for subfloor waterproofing. Shake product packs well before opening them. Mix 1 pack of Primer MF (part A + part B) and 1 bottle of Primer KL (1 litre) in a container. Then shake the liquid...

INFORMATION SHEET Apply the primer mixture created with a roller, taking care to cover the entire surface. Wait for product to dry. 2ND STEP Application of a second and last coat of primer for subfloor waterproofing. Wait 2 hours if the location is exposed to the sun. Shake product pack well before opening it. Mix Primer MF only (part A + part B) in a container. Shake the liquid well for thorough mixing of the various products. Apply a pure primer with a roller for enamel and resin applications (not a simple water-based paint roller), taking care to cover the entire surface (take special care...

INFORMATION SHEET The above mentioned operations for the preparation of concrete subfloors can only be carried out in the presence of temperatures between + 10°C and + 30°C. In the summer, it is advisable to perform operations early in the morning. When the second primer coat has also dried, remove all the quartz that has not been able to bind with the primer itself (sweeping it off with a broom for example). PREPARING PRE-EXISTING HARD FLOORING SUBFLOORS First check that all the elements that form the hard flooring are firmly attached to their subfloor. If not, re-establish proper adhesion where...

INFORMATION SHEET LISTONE GIORDANO MARINE GLUED-DOWN INSTALLATION Begin glued-down installation only in the presence of a perfectly dry concrete with primer or prepared hard flooring subfloor. There must therefore be no traces of moisture on surfaces, including dew. Spread the adhesive on the surface in areas that can be covered within 10-15 minutes with the Listone Giordano Marine decking to be installed. Spread the adhesive on the substrate using a toothed spatula like the one used on indoor parquet flooring, with dimensional characteristics as the image below. Apply the adhesive evenly across...