LightON 2

Product catalog summary

Overview: The document provides installation and technical specifications for a 1 Gang / 1 Way touch switch designed for intuitive lighting control without requiring a neutral wire at the switch.

Installation Instructions:

Ensure power is switched off at the distribution board before starting any work.
Attach the mechanism to its support, following the indicated orientation.
Install the glass panel from top to bottom, ensuring the tab is at the bottom, and confirm the circuit is off before fitting.
If the LED remains red, verify wiring connections.
To reset, press and hold the button until two beeps are heard.

Technical Specifications:

Manufacturer: Livolo
Reference: T01
Dimensions: 45 × 45 × 35 mm
Type: Touch switch
Warranty: 2 years
Number of circuits: 1 lighting circuit
Rated voltage: 220-240 V AC, 50/60 Hz
Rated current: 5A
Maximum load: 2000W
Minimum load: 5W
Operating temperature: -10°C to +40°C
Permissible humidity: up to 95%
Connection type: Screw terminal
Cable cross-section: 1.5 to 2.5 mm²
Stripping length: 6 mm
Certifications: CE & RoHS

Installation & Compatibility:

Compatible with round or square flush-mount back boxes ≥ 40 mm.
Suitable for horizontal or vertical installation.
Designed for use on existing standard electrical installations.
No neutral wire required at the switch; neutral required only at the light fitting.
Compatible with LED and halogen lighting.

Additional Components:

Requires a tempered glass faceplate, available in Glossy or Matte finish, and a metal mounting frame.

Wiring Diagram & Best Practices:

N (neutral) = blue
L (line) = any wire except blue and green/yellow
PE (earth) = green/yellow

Catalog excerpts

1 Gang / 1 Way touch switch Touch control mechanism designed to operate a lighting circuit simply and intuitively, with no neutral wire required at the switch. General specifications Installation & compatibility • Compatible with round or square flush-mount back boxes > 40 mm • Suitable for horizontal or vertical installation • For use on existing standard electrical installations • No neutral wire required at the switch (neutral required only at the light fitting) • Halogen lighting • A tempered glass faceplate, available in Glossy or Matte finish, and a metal mounting frame Technical specifications • Manufacturer Livolo • Type touch switch • Number of circuits 1 lighting circuit • Connection type screw terminal Wiring diagram & installation best practices Clip the mechanism onto its support, making sure to follow the indicated installation orientation Make sure the circuit is switched off before fitting the glass panel. If the LED lights up and remains red, check the wiring connections. L (line) = any wire except blue and green/yellow 300 avenue des Mattes ZI Athelia 1 | 13600 La Ciotat | www.lighton-solutions.com © 2026 LightON - All rights reserved. Any reproduction, in whole or in part, is prohibited without

Open the catalog to page 1