1 Gang touch push-button switch Description Touch control mechanism designed to operate a lighting circuit via an impulse relay. General specifications Technical specifications • Manufacturer Livolo • Reference T01H • Dimensions 45 × 45 × 35 mm • Type 1-gang touch push-button switch (momentary) • Warranty 2 years • Number of circuits 1 lighting circuit • Rated voltage 220–240 V AC, 50/60 Hz • Rated current 5A • Maximum load 2000W • Minimum load 5W • Operating temperature -10°C to +40°C • Permissible humidity up to 95% • Connection type screw terminal • Cable cross-section 1.5 to 2.5 mm² • Stripping length 6 mm • CE & RoHS Installation & compatibility • Compatible with round or square flush-mount back boxes ≥ 40 mm • Suitable for horizontal or vertical installation • For use on existing standard electrical installations • No neutral wire required at the switch • Suitable applications: impulse relay, automation system, home automation control, relay logic input To be completed with • A tempered glass faceplate, available in Glossy or Matte finish, and a metal mounting frame Wiring diagram & installation best practices Switch off the power at the distribution board before carrying out any work. Clip the mechanism onto its support, making sure to follow the indicated installation orientation. Clip the glass panel into place from top to bottom, with the tab at the bottom. Make sure the circuit is switched off before fitting the glass panel. If the LED lights up and remains red, check the wiring connections. To reset the mechanism, press and hold the button until you hear two beeps. N (neutral) = blue L (line) = any wire except blue and green/yellow 300 avenue des Mattes ZI Athélia 1 | 13600 La Ciotat | www.lighton-solutions.com © 2026 LightON – All rights reserved. Any reproduction, in whole or in