Airtight flush-mount back box 1 Gang Description The XL Air’métic Ø67 mm back box ensures airtight sealing of electrical wiring accessories while reducing heat loss, ideal for low-energy buildings and projects compliant with RT2012 and RE2020 standards. General specifications Technical specifications • Manufacturer Eurhom • Reference 52061 • Type XL Air’metic flush-mount back box • Depth 40 mm • Diameter 67 mm • Main material blue plastic and grey SBS membrane • Glow-wire resistance 850°C • Protection rating IP40 / IK04 • Operating temperature -5°C to +60°C • Storage temperature -10°C to +70°C • Warranty 2 years • Certification NF EN 60670-1 Installation & compatibility • Installation type dry lining • Compatible with ICTA conduits D16 / D20 / D25 To be completed with • All types of mechanisms Installation best practices Switch off the power at the distribution board before carrying out any work. Make sure the circuit is switched off before fitting the glass panel. Clip the mechanism onto its support, making sure to follow the indicated installation orientation. If the LED lights up and remains red, check the wiring connections. Clip the glass panel into place from top to bottom, with the tab at the bottom. To reset the mechanism, press and hold the button until you hear two beeps. L (line) = any wire except blue and green/yellow 300 avenue des Mattes ZI Athélia 1 | 13600 La Ciotat | www.lighton-solutions.com © 2026 LightON – All rights reserved. Any reproduction, in whole or in part, is pr