B_SLC1141 Product description One downlight for all applications! Tilts 30° in all directions (360°). For new and rehab projects. Can be mounted into insulation, up to the moisture barrier. Quick and easy installation We have always been thinking about the electrician when developing our products. Focusing on solutions which is practical and easy for the installer. One 360º and OneSoft comes with a quick connector between the downlight and driver so you can easy detach the downlight from the driver. We also use quick connection boxes with strain relief and connection for tubes. One downlight for indoor and outdoor use We have created a downlight which is suitable for outdoor and indoor use. The downlight is not 100% water sealed but it is resistant enough to be used outdoors (IP44). Perfect for rehab projects We created a downlight for all excisting cut-out holes from 68-83 mm. This combined with low installation height of just 46 mm, makes this downlight perfect for replacing old halogene downlights. You can also install these downlights directly into the insulation. SLC One360° for new and rehab projects Can be mounted into insulation, up to the moisture barrier No installation box required Tilts 30° in all directions (360°) Suitable for outside installation Quick Connection 16 mm Cable/Tube connection Technical data Suitable for built-in mounting Suitable for wall mounting Suitable for suspended mounting Suitable for ceiling mounting Lamp type With light source Material housing Surface protection Powder coating Material cover Plastic, transparent Voltage type Nominal voltage LED nominal current at constant current Type of control gear LED operating device current-controlled THE LIGHT GROUP GmbH Am Schafbrinke 62 | 30519 Hannover | Germany Tel.: +49 (0)511 - 807 486 10 | E-Mail: [email protected] THE LIGHT GROUP AS Sagmyra 2A, 4624 | Kristiansand S | Norway Tel.: +47 38 00 21 01 | E-Mail : post@tlg

Datasheet Control gear included Dimming phase cut-off Light distributor Light sharing Beam angle Light outlet Rated life time L80/B10 at 25 °C Protection class Rated ambient temperature according to IEC -10 - 45 °C Colour of light Colour rendering index CRI Power factor Outer diameter Built-in width Built-in height/depth Built-in diameter Suitable for through wiring Conductor cross section Connectable conductor cross section Connection type Plug clamp Luminaire efficacy Colour consistency (McAdam ellipse) Strain relief Colour rendering index (CRI/Ra) Operating temperature Can be installed directly...