HIDE Linear slot diffusers

CONTENTS HIDE linear diffuser

HIDE linear diffuser Description HIDE linear slot diffuser, air flow 21 mm, with no outer frames, thus offering excellent aesthetics. Its directional fin allows air flow to be adjusted from 0º to 180º. Includes supply plenum with volume control damper at the inlet. Applicable for variable-volume and constant-volume systems, as it is designed to maintain the ceiling effect (Coanda effect), even with primary air flows reduced to 20% of nominal air flow rate. Application The HIDE linear slot diffusers are especially recommended for ceiling installation (both continuous and modular) with installation...

HIDE Overall dimensions HIDE linear diffuser, fixed plenum, side entry HIDE linear diffuser, fixed plenum, top entry

HIDE Overall dimensions HIDE linear diffuser, removable plenum, side entry HIDE linear diffuser, removable plenum, top entry

Vk Effective supply velocity in m/s Pt Total pressure drop, in Pa dB(A) Sound power level in dB(A)

HIDE Selection Graphs Induction ratio The induced air flow inside the room can be estimated from the factor (qx/qo) which is determined by the parameters Xc in m (throw) and the effective area in m2 (Ak). Once the induction ratio is known, multiply by the supply air flow to obtain the total induced flow. qx/qo: Induction ratio. Quotient between the air flow for a throw, X, and the air flow supplied in the room. Temperature coefficient To estimate the air-jet temperature in the room, use the lower chart which is determined by the parameters Xc in M (throw) and the effective area in m2 (Ak). To...

Designs and finishes Execution Air flow orientation based on deflector slot position. a) Position of air deflector slots for horizontal diffusion toward the left. Position of air deflector slots for vertical diffusion. Position of air deflector slots for horizontal diffusion toward the right. Finishes - Final trim There are three final diffuser trim systems. R15 R8,7 R1,5 Final trim of 17 mm. Final trim of 8,7 mm. Final trim of 1,5 mm. If not otherwise specified, the standard size is 1,5 mm. Diffusers with length above 2000 mm. Diffusers with a length above 2000 mm are supplied in separate sections...

THIS CATALOGUE IS INTELLECTUAL PROPERTY. Its reproduction either of a part or its full contents is prohibited without the expressed and authentic consent of KOOLAIR, S.A. CEN-HIDE-0116-00

KOOLAIR, S.A. Calle Urano, 26 Poligono industrial nº 2 – La Fuensanta 28936 Móstoles - Madrid - (España) Tel: +34 91 645 00 33 Fax: +34 91 645 69 62 e-mail: [email protected]