*myarchiexpo

KB101

Product catalog summary

Product Overview: The KB101 Vertical Wall Mounted Baby Changing Station is available in three colors: Cream, Grey, and White Granite. It is designed for surface mounting and features a durable, high-density polyethylene body with Microban® antimicrobial protection.

Materials and Design: The station is constructed from FDA-approved high-density polyethylene, reinforced with a full-length steel-on-steel hinge mechanism. It includes 11-gauge steel mounting plates and hardware. The changing surface is contoured, measuring 420 sq. in (2710 sq. cm), and includes nylon safety straps and two bag hooks. Graphics and safety messages are molded in six languages and Braille.

Operation: The unit features a concealed pneumatic cylinder for controlled opening and closing. It is easy to clean, resists odors and bacterial growth, and complies with ASTM static load performance requirements. A built-in liner dispenser holds approximately 25 sanitary liners.

Specifications: The station conforms to ASTM F 2285-04, ANSI Z535.4, ASTM G21, and ASTM G22 standards. It includes a 5-year limited warranty and provisions for vandalism replacement. The unit is manufactured in the U.S.A.

Installation Instructions: Installation should be performed by a qualified person. The unit must be mounted on a permanent wall capable of supporting significant weight. The vertical unit has four mounting holes positioned on a 16” (406 mm) stud center. Detailed steps are provided for drilling holes and securing the unit based on wall type, including wood studs, masonry, or tile over wood studs.

Contact Information: Koala Kare Products, 6982 S Quentin St., Centennial, CO 80112. Toll-Free: 888.733.3456, Phone: 303.539.8300, Fax: 303.539.8399, Website: www.koalabear.com

Catalog excerpts

KOALA KARE PRODUCTS KB101 VERTICAL WALL MOUNTED BABY CHANGING STATION KB101-00 CREAM KB101-01 GREY KB101-05 WHITE GRANITE Finish face of wall 5¼” (133 mm) KB101 TECHNICAL DATA SHEET

Open the catalog to page 1

MATERIALS: FDA approved blow-molded high-density polyethylene with Microban® antimicrobial. Reinforced full-length steel-on-steel hinge mechanism, with 11-gauge steel mounting plates and mounting hardware included. Molded in graphics & safety messages in six languages and Braille. Contoured changing surface area is 420 sq. in (2710 sq. cm) and comes complete with nylon safety straps and two bag hooks. OPERATION: Concealed pneumatic cylinder and hinge structure provides controlled, slow opening and closing of bed. High-density polyethylene is easy to clean and resists odors and bacterial growth....

Open the catalog to page 2

INSTALLATION: To ensure proper installation and compliance to building codes, it is recommended that a qualified person or carpenter perform the installation of the unit. The unit must be properly installed onto a permanent wall that is capable of supporting significant weight, and can accommodate the supplied installation hardware. Drilling holes and mounting the station: 1. Remove the station from the shipping container and check for any freight damage. Identify the best location for installing the baby changing station. Hold the unit in place, open the bed, and make sure that there is adequate...

Open the catalog to page 3