*myarchiexpo

KB100-ST

Product catalog summary

Product Overview: The Koala Kare KB100-ST is a horizontal recessed mounted baby changing station available in cream, grey, and white granite finishes. It features a stainless steel flange and is designed for ADA compliance when properly installed.

Specifications: The unit is made from FDA-approved high-density polyethylene with Microban® antimicrobial protection and an 18-gauge type 304 brushed stainless steel flange. It includes a reinforced steel-on-steel hinge mechanism, nylon safety straps, and bag hooks. The changing surface area is 442 sq in (2852 sq cm).

Operation: The station uses a concealed pneumatic cylinder for controlled opening and closing. It is easy to clean, resists odors and bacterial growth, and includes a built-in liner dispenser for approximately 25 sanitary liners.

Compliance and Standards: The unit conforms to ICC A117.1-2009, ASTM F 2285-04, ANSI Z535.4, and ASTM G21 standards. It complies with ADA regulations when installed correctly.

Installation Instructions: Installation should be performed by a qualified person. The unit requires a rough wall opening of 35½” W x 20½” H x 4¼” D. It is mounted using four ¼” x 3” wood screws. Proper alignment and leveling are necessary for secure installation.

Warranty: The product comes with a 5-year limited warranty covering materials and workmanship, including vandalism replacement.

Manufacturer Information: Koala Kare Products, located in Centennial, CO, provides customer support via toll-free and direct phone numbers.

Catalog excerpts

KOALA KARE PRODUCTS KB100-ST HORIZONTAL RECESSED MOUNTED WITH STAINLESS STEEL FLANGE BABY CHANGING STATION KB100-00ST CREAM KB100-01ST GREY KB100-05ST WHITE GRANITE 37” (940 mm) Finish face of wall Rough Wall Opening 35½” (902 mm) wide 20½” (521 mm) high 4¼” (108 mm) minimum recessed depth ADA Compliance (when properly installed) 4.4.1 Max. Protruding Objects 4.2.5 Forward Reach 4.2.6 Side Reach 4.27.4 Operation KB100-ST TECHNICAL DATA SHEET

Open the catalog to page 1

MATERIALS: FDA approved blow-molded high-density polyethylene with Microban® antimicrobial embedded in the plastic and 18 gauge, type 304 brushed stainless steel finish flange. Reinforced full-length steel-on-steel hinge mechanism, with 11-gauge steel mounting plates and mounting hardware included. Molded-in graphics and safety messages in six languages. Contoured changing surface area is 442 sq in (2852 sq cm) and comes complete with nylon safety straps and bag hooks. OPERATION: Concealed pneumatic cylinder and hinge structure provides controlled, slow opening and closing of bed. High-density...

Open the catalog to page 2

To ensure proper installation and compliance to building codes, it is recommended that a qualified person or carpenter perform the installation of the unit. The unit must be properly installed onto a permanent wall that is capable of supporting significant weight and can accommodate the supplied installation hardware. The Koala Baby Changing Station meets ADA regulations when properly installed. 1. Remove changing station from the 35-/1-(so2mm)apart inside measurement shipping container and check for any freight damage. Identify the best location for installing the unit. Hold the unit in place...

Open the catalog to page 3