KME Germany GmbH & Co. KG Q -tec® [GB] Copper tube for sanitary and heating applications Approved by the DVGW* Made with quality SANCO®  ! *German Technical and Scientific Association for Gas and Water (DVGW)

Copper tube for sanitary and heating applications

Durable product • Q-tec® offers the same long life as all copper tubes • he inner pipe is made of copper and thus offers copper’s well-proven T benefits for sanitary and heating applications • The use of copper ensures that Q-tec® is 100% diffusion tight High pressure resistance Thanks to the strength of the copper tube, Q-tec® is suitable for operating pressures of more than 30 bar (14 x 2, 16 x 2, 20 x 2) Low thermal expansion Q-tec®, like other copper tubes, shows a relatively small increase in length as a result of thermal expansion Easy to use Q-tec® is easy to bend, easy to cut and easy...

Typical applications Q-tec® • drinking water (cold and hot) • floor heating • cooling/heating of building components • ground collectors • cooling systems 2 drinking water (hot) drinking water (cold) heating systems cooling systems gas liquefied gas oil KME Germany GmbH & Co. KG — Q-tec®

Technical data • Tube material conveying fluids: copper • Cleanliness of inner surface in accordance with EN 1057 • aterial of outer cover: PE-RT M Heat conductivity: λ = 0,35 W/mK • Bore smoothness of the inner copper tube: 1.5 µm • Fire resistance: DIN 4102-B2/DIN EN 13 501-Klasse E • Colour: white, generally to RAL 9010 • 4 sizes available: see table 1 nominal outer diameter nominal inner diameter copper tube wall thickness max. pressure copper tube* coil length * safety factor 3,5 ** approval DVGW pending Form of delivery • 14 and 16 mm: 100m coils (50 m optional) • 20 mm: 50 m coils • 26...

• Uncoil Q-tec® coil on smooth or profiled insulation sheets • Cut with cutting tool (or saw) • Expand, round and debur the tube ends with a special tool • Bend by hand for bending radius > 80mm • Bend using a bending tool for a bending radius > 50mm Examples of jointing techniques • onnect to the manifold of a heating system C with a Euroconus ¾” screw joint • Make pipe connections using press fittings • cutting, rounding and deburring tool • screw spanner • bending tool Q-tec® – Registered Trademark of KME Germany GmbH & Co. KG KME Germany GmbH & Co. KG — Q-tec®

Laying Q-tec® tube Q-tec® can be laid on any suitable under-floor insulation available commercially or as part of a system. The coil is rolled out with the help of positioning foil on flat surfaces or on profiled plates. Material needed: positioning foil, profiled plates Bending The tube can be bent easily by hand. A tighter radius can be achieved using a bending tool or bending spring. Tools: bending tool or bending spring, as required Cutting to length, rounding, expanding and deburring The tube is cut to length using a Q-tec® tube cutter. Any burr is removed using the deburring tool, which...

All changes reserved. Owing to limitations in printing technology, the colours reproduced in this brochure should be regarded as approximate equivalents to the colours described. 0715.000.0100 Plumbing Tubes KME Germany GmbH & Co. KG Plumbing Tubes Postfach 3320 49023 OSNABRÜCK Klosterstraße 29 49074 OSNABRÜCK GERMANY Tel. +49 (0) 541 321-4329 Fax +49 (0) 541 321-82010 www.kme.com [email protected]