TECHNICAL DATA SHEET SIDING, FENCE & BARN PAINT AS OF 6/1/2011 COMPLIES OR IS CERTIFIED WITH: KILZ SIDING, FENCE & BARN PAINT_ KILZ® Siding, Fence & Barn Paint is a unique water/oil based formula that resists cracking, peeling and blistering. It's ideal forali exterior vertical wood surfaces and provides excellent adhesion to a variety of other surfaces such as laminates, masonry and stucco. Use on properly prepared vertical exterior surfaces, such as: • Laminates • Masonry • Stucco FILL/MAX TINT Sheen levels depend on porosity and various surface Vehicle: Oil/Latex Vehicle: Oil/Latex The addition of colorants may add VOCs. COVERAGE RATE gallon, depending on the surface texture, porosity and application method. Does not include the loss of material from spraying, RECOMMENDED FILM THICKNESS • No. 1011 (Red)-Wet: 3.2 mils; Dry: 1.1 mils PREMIUM APPLICATION TOOLS Airless Spray: Rough / Porous Surfaces: 1/2" - 3/4" nap Brush: Nylon/Polyester Blend SURFACE PREPARATION! •The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew and wallpaper paste. If washing Is necessary, use a non-soapy detergent or a TSP substitute. Rinse • To determine the condition of the surface, place cloth duct tape in several places on the bare wood. Press the tape down firmly and then remove quickly. If wood fibers or debris are pulled onto the tape, additional preparation Is • Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is • Mold or Mildew Covered Surfaces: Wash the area with a mildew remover, rinse with water and allow to dry before painting. • Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before • Only apply if surface, air and product (10°-32°C). Do not apply if rain is expected • Intermix containers of the same color to ensure color uniformity. • Stir thoroughly before and occasionally • Many woods contain tannin, which may cause discoloration. Prime these woods with one coat of KILZ® PREMIUM primer to reduce stains as needed. • Keep a wet edge, and always back-brush or back-roll during all application methods. • If two coats are necessary, apply the second coat only after the first coat has thoroughly • To Recoat / Topcoat: 6 - 8 Hours Application at lower temperatures, high humidity or poor ventilation will affect dry time. This information is provided "as is" and no representations or warranties, either express or implied, of merchantability, fitness for a particular purpose or of any other nature are made with respect to this information or to any product referred to in this information. For MSDS or to consult with a technical service representative, call 1-866-PRIMER-1.

TECHNICAL DATA SHEET KILZ® SIDING, FENCE & BARN PAINT SIDING, FENCE & BARN PAINT • Clean equipment and paint spatters with warm, soapy water. • If spilled, contain material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current federal, state and local regulations. • Do not dispose of this product down a drain, • Please consider donating any unused product. • For recycling or disposal Information, contact your local household refuse collection service, LIMITED WARRANTY If this product is found to be defective upon inspection...