BUILDING RANGE / Protection and decoration Keradecor Zinkover Base and finish coat glaze, resistant to atmospheric agents, excellent coverage and easy to apply with a brush. Keradecor Zinkover, highly protective and containing solvent-based synthesis resins, is suitable for the preparation of galvanized surfaces. Provides a high degree of protection from the effects of the weather and marine environments. Internal, external. GREENBUILDING RATING® PRODUCT STRENGTHS • Ideal for galvanized surfaces Product with none of the requisites of the GreenBuilding Rating ®, must be used with care. Kerakoll undertakes to improve the ratings of Rating zero materials and products. • High coverage • Easy to apply with a brush, roller or spray RATING SYSTEM ACCREDITED BY CERTIFICATION BODY SGS AREAS OF USE Use Glaze for: - galvanized sheet metal (guttering, down spouts, shutters, doors and windows, garage doors, gates, wire fences, fences, guard rails, awnings, trellises) - aluminium (guttering, down spouts, doors and windows) For internal and external use. Do not use On wet surfaces. Preparation of substrates New galvanized surfaces: degrease thoroughly using Keradecor Solmix Universal thinner. Apply Keradecor Zinkover directly, adjusting dilution with Keradecor Solmix Universal, as required for application by brush, conventional and airless spray. Slightly rusted galvanized surfaces: remove the rust completely by sanding and apply Keradecor Sintcrom. Apply Keradecor Zinkover, adjusting dilution with Keradecor Solmix Universal, as required for application by brush, conventional and airless spray. Galvanized surfaces painted with deteriorated products: remove all traces of the existing paintwork and wash thoroughly with Keradecor Solmix Universal. Apply Keradecor Zinkover directly, adjusting dilution with Keradecor Solmix Universal, as required for application by brush, conventional and airless spray. All the above mentioned substrates must be clean, dry and free from oil and grease. For the treatment of substrates other than those mentioned and for additional information on the types of intervention to be carried out, we recommend to consult Kerakoll’s Guide to decorating and preparing substrates. Preparation Always remix the product before application. Application Keradecor Zinkover must be applied carefully over the whole surface using a brush, roller or spray, first diluting by from 5% to 15% with Keradecor Solmix Universal thinner, according to the application method used. When applying by brush or roller, dilute Keradecor Zinkover with Keradecor Solmix Universal in a percentage of 5 – 10%. * ÉMISSION DANS L’AIR INTÉRIEUR Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions). Keradecor Zinkover Code: K704 2021/01

INSTRUCTIONS FOR USE When applying by spray, dilute Keradecor Zinkover with Keradecor Solmix Universal in a percentage of 10 – 15%. Application, particularly external application, requires two coats of the product to be laid, at a distance of at least 24 hours. Conditions required for decorating are ambient and substrate temperatures between +5 °C and +30 °C and relative ambient moisture lower than 80%. In cases where different lots of coloured product are used, or when completing a job in which a tintometer has been used, it is advisable to mix the various quantities together so as to avoid...