LAYING RANGE / Waterproofing Aquaform OD - OD Plus High quality ASA perimeter drain with seamless wall-floor sides coated in non-woven polypropylene to guarantee a good seal with Aquastop Nanoflex® mineral membrane, using eco-friendly Aquastop Fix sealant and gel adhesives from the Biogel® range. PRODUCT STRENGTHS • UV resistant • Paintable • High resistance to collision AREAS OF USE Use Balconies, terraces and horizontal external surfaces of any size. Creation of perimeter drains in Kerakoll® waterproofing systems. 1 Drill a hole diameter 60 mm in the wall close to the floor/parapet joint. In Aquastop Nanoflex® and Aquastop Flex waterproofing systems, make a suitable housing on the screed to guarantee the drain is perfectly level with the floor, and avoid counter-slopes in the floor near the water exit hole. 3 Insert Aquaform OD in the hole made as described above, and remove any excess Keralevel® Eco LR. Level Aquaform OD on the wall and floor (to ensure perfect levelling of the wall, mechanically chip out a suitable housing in which to position the drain). Aquastop Nanoflex® Waterproofing System 1 Once the Aquaform OD drain has been fixed, apply Aquastop Nanoflex® or Aquastop Flex on the fabric connection surfaces of the drain and on the support surfaces adjacent to the drain. 2 Fix Aquastop 120 on the fresh waterproofing product following the wall-floor joint. Press firmly and smooth over to ensure Aquastop 120 adheres perfectly, being careful not to wrinkle it. 3 When laying Aquastop Nanoflex® or Aquastop Flex, cover the Aquastop 120 carefully. 2 Use Keralevel® Eco LR for the provisional fastening and the filling: apply the levelling product to the Aquaform OD outlet pipe and to any housing formed in

INSTRUCTIONS FOR USE Aquastop Green Waterproofing System 1 Lay Aquastop Fix on the black TNT connection surfaces of the Aquaform drains and on the adjacent surfaces to be connected, taking care to fill in the Aquastop Green surface cavities. 2 Position the special pieces of Aquastop 100 cut to measure. TECHNICAL DATA COMPLIANT WITH KERAKOLL QUALITY STANDARD Material Colour Connector height Connector width Total length Inlet Outlet Flow Aquaform OD Plus ASA Grey ≈ 120 mm ≈ 300 mm ≈ 460 mm ≈ 90x90 mm ≈ 75x75 mm ≈ 8 ℓ/s 3 Press firmly and smooth over to ensure the tape seals perfectly, being careful...

TECHNICAL DIAGRAMS Aquaform OD 300 mm 85 mm WARNING - Product for professional use - abide by any standards and national regulations - do not heat with a live direct flame - the product is an item according to the definitions of the EC Regulation No. 1907/2006 and therefore does not require a Safety Data Sheet - for any other issues, contact the Kerakoll Worldwide Global Service +39 0536 811 516 - [email protected] The Rating classifications refer to the GreenBuilding Rating® Manual 2013. This information was last updated in June 2021; please note that additions and/or amendments may...