Kent Diamond Tactile Warning Strip
7Pages

Kent Diamond Tactile Warning Strip

KENT STAINLESS: STRIP -& Kent Diamond Tactile Warning Strip - KDTWS-35/420 ^ E? f“l t Features: • Underfoot warning to identify hazards and dangerous areas • Grade 316 Stainless Steel • Easy installation • Diamond ridge finish • UKAS certified Slip resistant Specify Kent Diamond Tactile Warning Strip KDTWS-35/420; 16.53" (420mm) length, 1.38"(35mm) wide; 0.20" (5mm) high, diamond ridge finish, with 3nr 0.24" (6mm) dia x 0.55" (14mm) stud for root fixing below GL, Grade 316 Stainless Steel. Description Kent Diamond Tactile Warning Strips Grade 316 Stainless Steel; Polished finish. The Kent...

KENT STAINLESS: STRIP Kent Diamond Tactile Warning Strip - KDTWS-35/420 Product Code Fixing method : There are three 0.63" (16mm) high x 0.24" (6mm) wide Bolts which are chemically cemented into the ground. The fixing points are spaced at 6.69" (170mm) centres. Note: The UK Slip Resistance Group recommends the following guidelines, PTV 0-24 High Slip Potential, PTV 25-35 Moderate Slip Potential, PTV 36+ Low Slip Potential. Testing Report available on request

3 KENT STAINLESS: STRIP Kent Diamond Tactile Warning Strip - KDTWS-35/420 Stainless Steel Maintenance Clean the stainless steel components using warm water with a mild detergent with a non abrasive cloth or sponge. Heavier stains may require the use of a nylon scouring pad or a stainless steel cleaner. To remove paint or graffiti (or light concrete splashes) use a cloth and alkaline or solvent paint strippers according to type of paint. For Satin Finish Stainless try to follow the direction of the grain when cleaning vigorously or polishing. For Bead Blasted Finish use a circular motion....

KENT STAINLESS: STRIP 4 Kent Diamond Tactile Warning Strip - KDTWS-35/420 Regulations & Guidelines: In DDA regulations it specifies that Strips are to be placed at 1.97” (50mm) centres running transversely across the direction of pedestrian travel. The bars are 0.20” (5mm) high, 1.38” (35mm) wide and spaced 1.97” (50mm) from the centre of one bar to the centre of the next bar. (As Shown in the Diagram below) Our standard Kent Diamond Tactile Warning Strip is 16.53” (420 mm) x 1.38” (35mm). This means we must leave a 0.59” (15mm) gap from end to end of each Strip. For more information on the...

5 KENT STAINLESS: STRIP Kent Diamond Tactile Warning Strip - KDTWS-35/420 Testimonials “ The In-house engineering completed by Kent Stainless and the Knowledge and advice given to finalise the design was outstanding” - Parsons “ The client and the main contractor both were delighted with the quality of the work supplied by Kent Stainless” - Skanska “ Because of the engineering know-how you provided and flexibility in design, we will certainly return to Kents for further work ” - Wexford County Council

Kent Stainless Ltd Ardcavan, Wexford, Ireland TEL NO: +353 53 9143216 EMAIL: info@kentstainless.com