POLYPRIME PU 880 POLYURETHANE-BASED, TRANSPARENT, TWO COMPONENT, PRIMER, USED AS PRIMER COMPONENT FOR POLYURETHANE-BASED INDUSTRIAL COATINGS GENERAL CHARACTERISTICS POLYPRIME PU 880 is a clear, polyurethane-based, two-component resin, which is used as an adhesive component between the sub-floor and all the polyurethane-based industrial coatings.   Ideal for old and new cement-based surfaces. TECHNICAL DATA Penetrates in depth and secure proper adhesion. Eliminates dust from decay in old & new floorings, reinforcing their durability. two-component polyurethane light brown Mixing proportion: Temperature for the application and drying of the material: > 3 N/mm (breaking of concrete) Adhesive strength: SUBSTRATE REQUIREMENTS Concrete quality: Moisture content:

Applied on dry surfaces, free of materials that might prevent bonding e.g. dust, loose particles, grease etc. The success in the application depends on the right preparation of the underlay and use of the material.  Good, dry cleaning of the surface from dust and residues. Caution must be taken so that temperature of the substrate as well as ambient air remains ο above 12 C during application and curing of the materials while relative environment humidity does not exceed 75%. Good mixing of components A (resin) & B (hardener) packed into separate containers in fixed weight proportions. Mixing...

precautions measurements of humidity with special device are suggested.   It cannot be applied in thickness for filling in cracks or holes. The cement subfloor must be thoroughly cleaned and smooth, moisture content below 4%. The application must take place in well-aired places using protective gloves. Skin or eye contact must be avoided, otherwise wash carefully with soap and water. For more information consult the material safety data sheet. The information given here is true, represents our best knowledge and is based not only on laboratory work, but also on field experience. However, because...

ELASTOPOL PU 883 POLYURETHANE BASED, SELF-LEVELING, TWO-COMPONENT, HEAVY DUTY FLOOR COATING GENERAL CHARACTERISTICS ELASTOPOL PU 883 is a colored, industrial, polyurethane-based, resilient floor coating suitable for indoor dry areas with medium to hard traffic. Prevents dust creation and decay, creates an easy-to clean, maintenance-free seamless surface meeting health standards, protects cement-based surfaces and provides a surface with resistance to oils, fats, grease, acids, alkalis etc. Recommended for food industries, dairy factories, slaughterhouses, waste treatment plants, pharmaceutical...

Caution must be taken so that temperature of the substrate as well as ambient air remains ο above 12 C during application and curing of the materials while relative environment humidity does not exceed 75%. Application of POLYPRIME PU 880 two-component polyurethane-based primer. The next day, depending on the ambient temperature, follows the application of ELASTOPOL PU 883. Components A (resin) & B (hardener) packed into separate containers in fixed weight proportions are mixed together using a low revolution mixer (300600 rpm) for 1-2 min. Stirring of the mixture should be performed thoroughly...

Do not apply to floors if there is moisture in the subfloor drive or hydrostatic pressure. Prior precautions measurements of humidity with special device are suggested. In case old floors are going to be laid or a long period of time (more than 18 hours for summer and 36 hours for winter) interferes between successive layers, the surface must be thoroughly cleaned and grinded prior to application of a new layer. All surfaces should be thoroughly cleaned from dust and residues prior each application. Do not mix or apply unless surface, air and material temperatures are over 12°C during the next...