Plastmo U-Snap Vinyl Rainware Pamphlet
2Pages

manufactured by: Plastmo answers all your Rainware needs with an extensive line of vinyl rainware products manufactured following state-of-the-art methods. Vinyl Rainware System Snap Together - Do It Yourself Durable - Easy to Install Built on more than 40 years of experience; you can count on the quality and durability of our products. See temperature lines inside the drop outlet for proper placement of gutter. Note: Do not cement gutter to drop outlet. Second side of corner can now be cemented to clean surface of gutter. Engage gutter by pushing it up the back edge of corner, then push front of gutter so that “Lock Rim” snaps into place. Half Round Vinyl Rainware STEP 1: Install drop outlet (U11) at predetermined downspout location. Install a hanger (U06) at highest point on fascia board at farthest point from drop outlet. Always slope down to downspout location. Mark chalk line and position hangers every 24". Slope should be 1/4" per 10 ft. End cap (U08) may be attached directly to drop outlet if at end of a gutter run. If gutter continues around corner, position hangers at same height and no closer than 12" from corner. Join gutter sections at roof level. Apply cement on cleaned connectors (U02) from front to back. Hook connector onto rear edge of gutter, and then press connector onto front of gutter so “Lock Rim” snaps into place. Vinyl Rainware System STEP 2: Install elbow (K13) onto drop outlet. Measure downspout and cut to size between elbows. Install third elbow at bottom of downspout using downspout bracket (K14) as shown. Also install downspout bracket at top of downspout and at downspout connector (if necessary). Note: Do not cement elbows or downspout. Vinyl Rainware System Lightly sand surfaces to receive cement with 100 grit paper. Surfaces should be clean and dry. Minimum temperature should be 32° F. Drying time of cement is approximately 30 seconds. Use Plastmo cement only. Install end caps while still on ground. Small guides will keep it in place while cement dries. For corners apply cement in zig-zag pattern from front to back. Plastmo follows rigorous quality control and testing, meeting and exceeding the most stringent industry and government standards, at all stages of manufacturing. Install gutter section with attached corner (U04) and/or end cap (U08) onto hangerss. Push rear edge of gutter up into hanger then snap front top of gutter over front tip. Make sure all cemented fittings are at least 2" away from hangers. USP-NE ©2008 PLASTMO Vinyl Rainware System

Vinyl Rainware System Each component is designed and manufactured for durability and ease of installation. Snap Together Do-It Yourself Complete U-Snap Rainware System Leaf Guard U06 Hanger The U-Snap Leaf Guard is the perfect complement to your rainware installation. It keeps leafs and large debris out of your gutters. Gutter not included. VERTICAL COMPONENTS U11 Drop Outlet K21 Ribbed Downspout Connector 10 ft. lengths. Gutter may be cut to fit any size. Divide the total lineal feet of the project by 10 to determine the number of gutter pieces required. For securing downspout to the wall....