System STANDARD In screed underfloor heating INTRODUCTION System STANDARD is a traditional ‘pipe embedded in screed’ underfloor heating system, Using low temperature warm water, System STANDARD effectively heats buildings by radiating heat through a heated screed. JUPITER System STANDARD can be installed within 50mm anhydrite screed or 65mm sand cement screed. Suitable for domestic and light commercial applications System STANDARD provides a cost effective heating solution for solid concrete and beam and block floor constructions. Unlike other manufacturers JUPITER supply a thin Neopor® insulation layer as part of the system which, when installed on upper floors, meets Part L and contributes to Part E Building Regulations requirements. CONTROL JUPITER offer Individual room control with either hard wired or state of the art wireless thermostats and low power consumption mixing valves and pumps which allow our systems to be combined with traditional radiators. DESIGN SERVICE We provide a design service, including heat output calculations and heating circuit layouts. INSTALLATION In most cases the JUPITER System STANDARD is installed either by our own engineers or by independent installers located around the UK. The system can be installed by self builders and we can issue a DVD which demonstrates all aspects of our various systems. We also supply comprehensive layout drawings as well as technical advice and after sales support. Ground floor construction Intermediate floor construction 65 sand / cement screed 65 sand / cement screed 50mm anhydrite screed Neopor 27mm insulation Slab 50mm anhydrite screed Neopor 18mm insulation Insulation - non specific Slab JUPITER Heating System Ltd,Unit 1,The Barns,Pennypot Lane,Chobham,Surrey,GU24 8DJ T +44 (0) 1276 859 066 F +44 (0) 1276 856 894 www.jupiterunderfloorheating.com “…no need to screed” ™

System STANDARD In screed underfloor heating JUPITER PIPE At the core of the JUPITER heating system is our multi layer aluminium / polyethylene PE-RT pipe. The advantages of both metal and polyethylene are combined to give an air tight, long lasting and corrosion free pipe. JUPITER multi layer pipes are manufactured in Germany and are tested and approved to the highest standards. 1 Polyethylene pipe 2 Adhesive layer 3 Aluminium pipe 4 Adhesive layer 5 Polyethylene pipe 1 2 3 4 5 The JUPITER IDEAL UFH system and associated products has been tested to, and met the following standards: BS EN 1264,...