John L. Lord & Son Ltd Ainsworth Road, Bury Lancashire, BL8 2RS SPECIALIST FLOORING Technical Data Sheet Product Description Uragard HT100 is a fast-curing, heavy-duty, polyurethane flooring system with built-in flexibility, making it particularly useful for freezer or cold room environments. Uragard HT100 ensures a durable, impact and wear resistant surface at operating temperatures from -5ºC to -35ºC. Suitable for freezers / cold rooms Anti-slip surface Fast curing, single application Excellent chemical resistance Excellent impact and wear resistance at -5ºC to -35ºC Temperature resistant from 50ºC to -35ºC Optional biocide additive Technical Data John L. Lord & Son Ltd is an ISO 9001:2008 accredited company and all products are manufactured strictly to ISO quality standards. Performance Data at temperatures between -5ºC and -35ºC Compressive Strength: Flexural Strength: Bond Strength to Concrete: Exceeds cohesive strength @ 30N/mm2 Tensile Strength: Temperature Resistance: Flash Steam Cleanable: Water Permeability: Uragard HT100 is classified as Low Slip Potential Flooring (both wet and dry) as described in ‘The Assessment of Floor Slip Resistance: The UKSG Guidelines issue 4 / 2011’. Results were obtained from tests carried out by the Health and Safety Laboratory (HSL) and from our own internal laboratory tests. Continued slip resistance can only be maintained if the guidelines in the HSE’s STEP tool (Slips and Trips eLearning Package) are followed. All figures are measured and expressed under laboratory conditions: Actual performance may vary from the above values depending upon site conditions. © John L. Lord & Son Ltd; URAGARD HT100 / 1 of 2 1 coat Uragard primer Sealer Coat(s): Optional Variations: Physical Properties Complies with BS 8204-6 / FeRFA Type 6, System Make-Up: Biocide additive, glazed sealer coats (Uragard SC2 or MB12) System Details: Finish Seal: Resin rich anti-slip Grey, Red, Green, Buff, Cream or Terracotta Chemical Resistance Resistant to a wide range of chemicals. For full details consult the John Lord Technical Dept. Curing Time Floor can go into service after the following minimum cure period at 18ºC and above: Light Traffic: Heavy Traffic: Note: Uragard HT100 must be allowed to cure fully for 7 days prior to exposing system to operating temperatures below 0ºC. Shelf Life and Storage The product should be kept in its original unopened container until use. The product should be stored in weather tight conditions at temperatures between 10ºC and 25ºC, avoiding direct sunlight. Under these conditions this product has

Technical Data Sheet Application Information In-Service Maintenance John Lord recommends that all products are installed by their own Contracts Department who provide a professional service with experienced Project Management supervision and skilled, trained and NVQ/CSCS approved employees. Good housekeeping and regular cleaning can considerably extend the service life of a resin screed floor and will enhance the floor’s appearance and reduce soiling tendencies. Suitable Applications • Freezer, Chiller and Cold Room Environments Substrate Suitability and Preparation A separate technical data...