John L. Lord & Son Ltd Ainsworth Road, Bury Lancashire, BL8 2RS SPECIALIST FLOORING Technical Data Sheet EPIGARD Fastrac Product Description Epigard Fastrac is a highly advanced, two part epoxy-based resin primer and sealer specifically designed for use over concrete substrates without effective damp proof membranes and which are either too damp or insufficiently cured to allow the use of standard primers. When cured, Epigard Fastrac is suitable as an undercoat with all Epigard finishing systems and most Uragard performance screed systems. Excellent adhesion to wet, damp or partially cured concrete Provides a vapour-proof barrier to rising dampness Solvent free Easy to apply Physical Properties Complies with BS 8204-6 / FeRFA Type 1, Finish: Standard Colours: Chemical Resistance Resistant to a wide range of acids, alkalis oils and greases. For full details consult the John Lord Technical Dept. Curing Time At 18ºC, the primer/sealer is ready for overlaying in 6 to 8 hours. Shelf Life and Storage The product should be kept in its original unopened container until use. Technical Data John L. Lord & Son Ltd is an ISO 9001:2008 accredited company and all products are manufactured strictly to ISO quality standards. Performance Data Epigard Fastrac Primer/Sealer Part A: Density at 20ºC: Medium Epoxide Equivalent Weight: Flash Point: Bond strength to concrete Exceeds cohesive strength @ 30N/mm2 Application Information Water Permeability: The product should be stored in weather tight conditions at temperatures between 10ºC and 25ºC, avoiding direct sunlight. Under these conditions this product has a shelf life of up to 12 months. Epigard Fastrac Primer/Sealer Part B: Density at 20ºC: Solid Content: Flash Point: Water Permeability: All figures are measured and expressed under laboratory conditions: Actual performance may vary from the above values depending upon site conditions. © John L. Lord & Son Ltd; EPIGARD Fastrac / 1 of 2 John Lord recommends that all products are installed by their own Contracts Department who provide a professional service with experienced Project Management supervision and skilled, trained and NVQ/CSCS approved employees. Suitable Applications • Wet, damp or partially cured concrete • Environments with excessive humidity Substrate Suitability and Preparation A separate technical data sheet is available on ‘Substrate Suitabil

Technical Data Sheet EPIGARD Fastrac Application Temperature Correct temperature is critical to the successful application of Epigard Fastrac and air temperatures should be maintained between 15ºC and 20ºC during the application and curing period of this product. We also strongly recommend that the application area is heated to temperatures of between Application Temperature (cont.) 15ºC and 20ºC for up to 24 hours prior to application to allow the ambient and substrate temperatures to regulate before the application commences. Materials should also be kept in a warm area of 12ºC minimum temperature...