Catalog excerpts
Installation instructions for HALO soap dispenser 1 Dispenser 1 Opening Key 4 Fitting Screws and Plugs Tools Required: Drill Scre
Open the catalog to page 1
Open the unit with the key provided.
Open the catalog to page 2
Remove the reservoir and put to a side for installation.
Open the catalog to page 3
Mark out the holes for fixings.
Open the catalog to page 4
Please see the pre-installed spirit level to aid installation.
Open the catalog to page 5
Drill the marked out holes to the size of the fixings provided then use a screwdriver to fix the unit to the wall. The unit should be hand tight to the wall
Open the catalog to page 6
Reattach the reservoir and fill it with the relevant product to the pump supplied.
Open the catalog to page 7
Prime the dispenser by pushing the button, after a few pumps, the soap should start to flow, and the unit is ready to be used.
Open the catalog to page 8All JDS Products Ltd catalogs and technical brochures
-
DMK11-WK/NT1 Pages
-
DMB11-WK/NT1 Pages
-
DMS11-WK/NT1 Pages
-
HALO centrefeed dispenser5 Pages
-
PL11SMBS1 Pages
-
PL10SMBS1 Pages
-
PL10FMBS1 Pages
-
PL10LMBS1 Pages
-
PL03MBS1 Pages
-
PL01MBS1 Pages
-
LARGE JUMBO DISPENSER2 Pages
-
HALO mini jumbo dispenser5 Pages
-
HAND TOWEL DISPENSER2 Pages
-
SMALL HAND TOWEL DISPENSER2 Pages
-
PL07MWH1 Pages
-
PL31MBS1 Pages
-
PLJ40MGY1 Pages
-
PL20FMBS1 Pages
-
HALO2 Pages
-
BRK04MBS1 Pages
-
PL70MBS1 Pages
