Technical Data Sheet 11/15 Ultra-RS Renovierspachtel Ultra-RS Renovation filler Dispersion filler, ready-to-use, exterior and interior General description Type of substance: Dispersion filler Product properties: Good filling capacity, easy to draw out renovation filler. Resistant to shrinking and cracking up to 1 cm coating thickness. Deeper holes may be refilled after ca. 30 minutes. Ultra-RS has a good spreading rate and is thus economical due to its low specific weight. Exterior and interior. With exterior use, heed rain- and frost-free application requirements. Jansen Ultra RS is an extremely light filler for repairing holes, cracks, flaws and damaged areas. Easy to use since the material is supplied ready for use. The pasty viscosity enables non-drip and thick coat application. Suited for filling and smoothing damaged areas (dowel holes, breakouts etc.) in ceilings and walls made of gas concrete, gypsum board, wood, gypsum, plaster, brickwork and concrete. Ultra RS is also ideally used in model making due to its light weight. Not suited for use on metal or plastic surfaces. Colour shade: Packaging sizes: Technical data Binder base: Acrylic dispersion Pigment base: Titanium dioxide Application temperature: For object and ambient air not below + 5°C and not above +35°C (23°C 60% rel. humidity) Layer thicknesses of up to 1 cm may be coated over after ca. 30 minutes; coating thicknesses > 1 cm after 2 hours. Ultra-RS is fully hardened after drying overnight. Values may vary considerably at higher humidity or lower temperatures. With acrylic varnishes and dispersion paints or pasted over with wallpaper.

Page 2 of 2 Product code: Processing method Coating methods: With any rust-free stopping knife Substrate preparation: The substrate must be stable, dry, clean and free of separating substances (oil, grease, wax). Prime porous and absorbent substrates beforehand. Clean and dust plaster and drywalls. Clean and slightly moisten concrete and gas concrete. Clean and slightly moisten rendering and brickwork. Depending on subsurface absorbency, prime interior untreated wood with Acrylic Multi-primer or Jansen Aqua priming varnish. Hardboards must always be primed. Old plaster surfaces always require...