Page i of 5 Technical Data Sheet 01.26 BASt test number for white: 2012 1DS 01.13Generaldescription Material type: Low-solvent, aromatic-free, single-component high-solid paint. Area of use: The Road Marking HB is ideal for lines and symbols (VZ) in outdoor areas that are exposed to highstress. Suitable substrates: Bituminous substrates* (mastic asphalt, asphalt concrete), concrete and cement-bound substrates and interlocking paving stones. White colour with BASt (German Federal Highway Research Institute) approval also allows for use in public transport areas. Application spedficctioosccobefoundunde rthe heading"Application". * Large-scale application on asphalt surfaces is not recommended, as stress-related cracking may occur. Product features: » Quick-drying » High coverage » Clearly visible » Self-cleaning through weathering Colours: White, traffic yellow approx. RAL 1023, red approx. RAL 3020, blue Package sizes: White: 750 ml, 2.5 litres, 5 litres and 15 kg net Also available in 40 kg EWH (on request) Colourful: 750 ml, 2.5 litres (Traffic yellow also available in 15 kg)

Binder base: Gloss level: Technical Data Sheet 01.26 Acrylate Titanium dioxideand lightfattcolou r pigmnnts 1.500 -1.600 g/cm3 depending on colour shade Matt Viscosity: Thixotropic, ready for use Thinning agent: Only use special thinners for 1K solvent-based marking paints. Max. 2% Working temperature: Ambient temperature: minimum +5°C Drying: (23°C, 60% relative humidity) Loadable: after approx. 30 minutes The drying time depends on the wet film thickness, temperature, humidity and the material and ceiling temperature. Only open the roadways to traffic after the contractor has checked that they...

Substrate preparation: Technical Data Sheet 01.26 The area to be marked must be completely dry, free of dust and separating substances (oil, grease, wax) as well as algae and moss. Remove brown discolouration caused by foliage using high -pressure cleaning. Humic acid contained in foliage has a negative effect on shelf life. Old markings, chewing gum residue and other bonding difficulties must be removed mechanically. Substrate preparation: Concrete or cement -bound substrates: Surface components that interfere with adhesion, such as fine mortar layers, concrete slurry or retarders applied to...

Technical Data Sheet 01.26 Stir well before use! To achieve a high dry film thickness, avoid thinning or thin only very slightly. On black surfaces, always apply the paint or roll it on quickly and thickly so that the bitumen tar components do not bleed through the paint and turn brown. To ensure better adhesion to concrete and concrete paving stones, the first coat should be thinned with 10% Jansen Special Thinner for 1K solvent-based markings. Jansen Road Marking Paint HB should be applied with a wet film thickness of 300 p. The BAST approval for white road marking paint only applies in conjunction...

Technical Data Sheet 01.26 Immediately with special thinner for 1K solvent -based marking paints (see tech. Information sheet) In frost-free, non-overheated rooms and in sealed original containers. Protect from direct sunlight and frost! This product is not subject to any VOC category. Please refer to our current safety data sheet on the Internet at www.jansen.de The technical information has been compiled in accordance with the current state of science and technology. However, the individual recommendations cannot be considered to be binding as application and processing methods are beyond our...