Technical Data Sheet 03/24 Material type: Product features: Water-based, diffusible paint Good-coverage single-component system for new coats and renovation coats on wooden, plastic and aluminium windows and doors, for dimensionally stable and reasonably dimensionally stable wooden components and zinc surfaces. When used on rigid PVC, aluminium and zinc, no separate bonding agent is required. Diffusible, low water absorption, materials with wood content are isolated, excellent adhesion, good flow, good edge coverage, block-resistant, water-based, creates an impressive surface. Package sizes: Technical data Binder base: Gloss level: Tinting colours: Cationic acrylate Approx. 1.180 -1.265 g/cm3 depending on colour shade Semi-matt after drying Tintable up to max. 2% with commercially available tinting concentrates or via the Jansen MIX system Slightly thixotropic Slightly with water. Apply undiluted to maintain the isolating effect. Working temperature: Over +7 °C for object and ambient air. Max. 25 C.

GISCODE for coating materials: Jansen mSTechnical Data Sheet 03/24 (23°C 60% relative humidity) Dust-dry: After approx. 1 hour Can be painted over after approx. 6 hours Fully cured: After approx. 2-3 days The values can vary greatly depending on temperature and humidity. Determine exact consumption by trial coating. Substrate preparation

Substrate preparation Technical Data Sheet 03/24NOTE: Wash the cleaned surfaces well with clean water. Sand hard PVC with 240 - 280 grit and clean. NOTE: Film-coated windows cannot be painted. White plastic windows mav only be painted with light pastel shades (thermal loading). If darker shades are to be used, check beforehand whether the plastic windows have a metal core. This can be tested with a strong magnet. Untreated aluminium: Thoroughly remove whitish corrosion residues with an abrasive pad and Jansen Metal Cleaner. Wash the cleaned surfaces well with clean water. For anodised aluminium,...

Technical Data Sheet 03/24 Spraying information ISQ-Venti Xtrem Important: Avoid high humidity, as the insulating effect suffers. Always ensure good ventilation or, when spraying, take a short break every hour and cross-ventilate briefly to remove the moist air from the room. The aforementioned tables were created under test centre conditions. On larger surfaces, you should expect to use nozzles with larger holes and/or wider spray angles. This must be tried out on the object. Clean spray equipment carefully, rinse with plenty of water, as a cationic dispersion is not compatible with other water-based...

Jansen mSTechnical Data Sheet 03/24 EU limit value for this product (Cat. A/d): 140 g/l VOC (2010) This product contains max. 30 g/l VOC. Please refer to our current safety data sheet on the Internet at www.iansen.de The technical information has been compiled in accordance with the current state of science and technology. However, the individual recommendations cannot be considered to be binding as application and processing methods are beyond our control and the different nature of the substrates requires working methods to be tailored accordingly from a professional and craftsmanship perspective....