Ahrweitex Fast-drying Filler
2Pages

Technical Data Sheet 07/13 Ahrweitex Schnellspachtel - Ahrweitex Fast-drying Filler universally applicable on wood and metal General Description Type of material: Fast drying spotting plastic filler Filling of wood pores, spotting of scratches, smaller holes and other damage to wood and metal. In case of particularly deep holes use 2-Component Polyester Filler. Fast-drying, good body and high elasticity. Ahrweitex Fast-drying Filler can be applied several times within a short period, one coat on top of the other. After drying, it can be easily sanded. Ahrweitex Fast-drying Filler distinguishes itself by its white shade. Max. wet-film thickness 1.000 µ. Packaging sizes: Technical Data Binder base: plastic combination Pigment base: titanium dioxide and fillers exterior and interior. During filling on wood outdoors, swelling and shrinkage of the wood can generally lead to flaking. For further information see data sheet no.18 of the German Federal Commission, Bundesausschusses Farbe und Sachwertschutz, Frankfurt. Processing temperature: For object and ambient air over +5 °C (23 °C 60 % rel. air humidity) with water-dilutable paints as well as synthetic resin paints recoatable after 3 - 4 hours (depending on layer thickness). With nitrocellulose, nitrosynthetic and spray-can paints, a final through-hardening of the filler (ca. 12 hours depending on the layer thickness) must be waited for

Technical Data Sheet 07/13 with water-dilutable paints (e.g. dispersion paints), synthetic resin paints as well as nitrocellulose, nitrosynthetic and spray-can paints (observe drying time). with Jansen Universal Thinner Description of processing technique Methods of application: with every filling knife Substrate preparation: The substrate must be portative, dry, clean and free of separating substances (oil, grease, wax). New iron parts before filling, clean and pre-coat with Jansen Rust Primer. Priming coat must be perfectly through-hardened before filling. Ahrweitex Fast-drying Filler can...