STRADA HYBRID

Optional towel rail 5 Which Jaga control system to choose 7 Connection left or right. 8 Controls below Standard) 8 With remote control 8 Most used connection sets 9 Guideline for limiting flow noise 20

STRADA HYBRID

STANDARD DELIVERY - Low-H2O heat exchanger with wall brackets and fixing kit, air vent 1/8” and drain plug 1/2” - partially assembled casing for a connection on the bottom left or bottom right - cover plate in stainless steel effect for the side panel at the opposite end from the valve - easy to install fan unit with operation, control and 24VDC power supply This heater is not equipped with a condensation monitor. It has to be integrated into the installation (only for cooling). Eco-friendly, scratch-resistant powder coating with high UV-resistance - traffic white RAL 9016 (133), soft touch lightly...

CONTROL SYSTEMS TYPE Jaga ACO (D09) POSITION CONTROL PANEL EXTERNAL 0-10 V WATER TEMPERATURE AIR TEMPERATURE CONTROL SENSOR SENSOR Jaga BMS 0-10V control (D03) JAGA ACO (D09) - The fan speed is selected manually in 3 modes via the control panel. - When the water temperature is lower than 24°C and the air is warmer than the water in the heat exchanger, the fans will start. The unit will then cool the area. - When the water temperature is higher than 28°C and the air is colder than the water, the fans will start. The unit will then heat the area. - The unit will automatically switch from heating...

STRADA HYBRID WHICH JAGA CONTROL SYSTEM TO CHOOSE Would you like the unit to have room temperature control? Yes, unit with integrated room temperature control Fans will start automatically when the internal control sends warm/cold water through the radiator. No, unit without integrated room temperature control Fans will start automatically when the external control sends warm/ cold water through the radiator STRADA HYBRID STRADA HYBRID Without 0-10V signal: - room thermostat (None-Jaga) - area control with room temperature control - boiler or heat pump control with room temperature control -...

STRADA HYBRID HYDRONIC CONNECTION Room temperature control on the unit SET Unit without integrated room temperature control Thermostatic radiator valve for heating, or for heating + cooling Match the casing on the chosen combination of control system / valve set Standard casing Connection left or right with controls above : Complete the radiator code with 30 (left) or 60 (right). ex. STRW 035 050 11 XXX D09 60 Connection left or right with remote control: Complete the radiator code with 00 (closed sides). ex. STRW.035 050 11 XXX D01 00

MOST USED CONNECTION SETS To the wall - FLOW ON THE OUTSIDE With Jaga H-valve To the floor - FLOW ON THE OUTSIDE With Gampper Vario DP Dynamic valve With Jaga H-valve With Gampper Vario DP Dynamic valve automatic flow limiter (20 - 340 l/h) automatic flow limiter (20 -340 l/h) fill in sleeve coupling code fill in sleeve coupling code fill in sleeve coupling code fill in sleeve coupling code To the wall - FLOW ON THE INSIDE With Jaga Crossflow valve To the floor - FLOW ON THE INSIDE With Gampper Vario DP Dynamic valve With Jaga Crossflow valve With Gampper Vario DP Dynamic valve fill in sleeve...

Type 11 Type 16 Type 21 Watts Watts Watts Watts Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. enter colour code enter control system code

Watts Watts Watts Watts Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. CLIMATE DESIGNERS

Watts Watts Watts Watts Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. enter colour code enter control system code

Watts Watts Watts Watts Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. CLIMATE DESIGNERS

HEIGHT 065 Type 11 Type 16 Type 21 Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. enter colour code enter control system code

HEIGHT 065 Type 11 Type 16 Type 21 Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. CLIMATE DESIGNERS

Output measured in accordance with EN16430 *Noise measurement according to ISO 3741:2010, at a 2-m distance from the unit and with an assumed room attenuation of 8 dB(A)/room volume 100 m3/ reverberation time 0.5 sec. enter colour code enter control system code

PARTS STANDARD DELIVERY: - grille - front panel - cover plates ORDER CODE CSTW 020 050 11 XXX STANDARD DELIVERY: - heat exchanger - wall brackets ORDER CODE HSTW 020 050 11

MOUNTING SET FOR BACK BAR (in pairs) ORDER CODE 5521 011 Number of brackets for heat exchanger - from lengths 050 to 120 cm: 2 units - from lengths 140 to 220 cm: 3 units - from lengths 240 to 280 cm: 4 units HEAT EXCHANGER ORDER CODE 5121 020 000 11 I— Type of heat exchanger '- Height STANDARD DELIVERY: - heat exchanger - incl. angled air vent and drain cock I— Type of heat exchanger 1- Length Overview types of heat exchangers EXTENDED AIR VENT W H35 H50 H65 H95 Order code

PARTS STANDARD DELIVERY: - control board with microcontroller ORDER CODE D01: Jaga TPT D03: Jaga BMS D09: Jaga ACO Which type of fan unit is suited for a type of heat exchanger? Strada Hybrid Type 10 Strada Hybrid Type 11 Strada Hybrid Type 15 Strada Hybrid Type 16 Strada Hybrid Type 20 Strada Hybrid Type 21 CLIMATE DESIGNERS