Warewashing Systems Delta® HT-E-SEER-S Delta® HT-E-SEER-S Models Delta HT-E-SEER-S Short/Underbar Design Standard Features • Steam Elimination • Energy Recovery System collects the hot water vapor inside the machine and uses it to preheat the incoming rinse water • Operates on a single cold water connection • Soft Start helps protect glassware from chipping and breaking • 6" ( 153 mm) clearance facilitates cleaning beneath the machine • Stainless steel rear dress panel • Automatic fill • Push button start • Door interlock • Pressure regulator • Water hammer arrestor • Built-in booster heater with Sani-Sure™ final rinse system • Automatic pumped drain for floor and wall drain installations • Stainless steel wash pump • Solid state controls • Digital LED display • Delime cycle • Simplified controls allow easy access for operation and service • Built-in chemical pumps and priming switches Mandatory Specs Specify voltage_ Options □ Drain Water Tempering Kit □ Scale Prevention System (SPS) □ Replacement Cartridge for SPS Accessories □ 36-Compartment Rack □ 4-1/8" tall (105 mm) □ 5-5/8" tall (143 mm) □ 7" tall (178 mm) □ Combination Rack □ Peg Rack NOTE: A vent hood is not recommended above the Jackson Delta HT-E-SEER-S as it does not produce excessive vapors. Always check with the local building code to know what type of ventilation is required for commercial dish machine or glasswasher installations in your area. Specifications • High temperature undercounter dishwasher with steam elimination and energy recovery • Operates on a single cold water connection • Uses 0.65 gallons (2.47 liters) of water per rack • Cleans 24 (20)* racks per hour • Cleans 864 glasses per hour • 12" (305 mm) chamber clearance Three selectable cycles: Normal - 145 seconds Heavy - 213 seconds Extra-Heavy - 313 seconds Air insulated between body and stainless steel housing One (1) each peg and combination rack included Intertek Intertek Durable stainless steel construction 1-year parts and labor warranty Racks per hour calculated with NSF suggested load time of thirty (30) seconds for front opening type

3 5/8 [91 mm] 8 1/2 [216 mm] Install Machine Drain Hose into 1 1/2 [38 mm] MIN Floor Drain or Sink Do NOT install Drain Hose to “bottom” of Floor Drain or Sink. This can cause splashback. Delta HT-E-SEER-S MACHINE DIMENSIONS INSIDE INSIDE CLEARANCE CLEARANCE HEIGHT WIDTH 12” (305 mm) Delta® HT-E-SEER-S DOOR OPEN DEPTH All dimensions from the floor can be increased 1” using the machine’s adjustable feet. *Back and side views shown with back panel removed. WALL CLEARANCE INSIDE CLEARANCE DEPTH A - Electrical Connection B - Water Inlet (with 6' hose) (3/4" Male GHT, connect to true 1/2" ID line,...