TECHNICAL DATA MEGASAFE Various EPDM colors are available upon request PACKING AND STORING Each pallet is wrapped and protected with waterproof polythene film. Inside storage is recommended to protected from rainfall. WARNINGS Make sure all the pads have the same temperature during the entire installation period. Lay down the pads 24 hours before the installation to allow them to get their original dimensions. Install all the pads in a single laying session in order to guarantee installation under similar conditions. INFLUENCE FROM ATMOSPHERIC CONDITIONS In order to get the idea application enviromental conditions the temperature of the application site place have to be above 4°C for at least 24 hours before the pads application. If the site application has temperature below to 4°C, please keep the pads stored for at leat 72 hours befor the installation at a temperature above 10°C. Do not install the pads on sites where the temperature is below at 4°C for long time.The pads have to be stored and installed on shadow in order to avoid pads overheating. The suggestions and technical information given above represent our knowledge regarding the properties and the product's uses. ISOLGOMMA reserve the right to modify or update this data without prior notice. This document is the property of ISOLGOMMA and all rights are therefore reserved.

RUBBER FLOORING TECHNICAL DATA MEGASAFE SAFETY FLOORING INSTALLATION INSTRUCTIONS The installation surface must be flat, stable and protected from frost.The best substrates are leveled bed of gravel (grain size:0-7mm, water-permeable) or concrete. On a gravel base the only possibility is a dry laying; on a rigid base (asphalt, concrete ...) the product can be dry laid or glued. GLUE APPLICATION Start the installation from the corner of the surface to be covered leaving exposed the pad side prepared for the connectors. Apply the glue on the concrete surface with a notched trowel of 3 mm Install...