Floor insulation TECHNICAL DATA Highmat LineAcoustic insulation for floating floors Technical specification Acoustic insulation panels made of two rubber bearings inserted in a polyesther fiber mat, with a total thickness of ... mm. The bearings are made of SBR and EPDM rubber granules and fibers compacted using polyurethane glue in a hot process, protected with a non-woven, non-stretch, synthetic membrane on one side; the dimensions of the rubber bearings are 300 mm x 50 mm3. The polyesther fiber mat has a density of... kg/m3 and the total dimensions of the assembled panel are 1000 mm x 600 mm. • Very high acoustic and thermal performance • Easy to lay • Wide versatility PACKING AND STORING Each pallet is wrapped and protected with waterproof polythene film. Inside storage is recommended to avoid possible wet storing. carried on a sample with dimension 20 cm x 20 cm, with relative quantities of supports and filler proportional to the panels', without gypsum plaster layer between steel plate and sample. The suggestions and technical information given above represent our knowledge regarding the properties and the product's uses. ISOLGOMMA reserve the right to modify or update this data without prior notice. This document is the property of ISOLGOMMA and all rights are therefore reserved. 1/2 ISOjGOMMA Isolgomma Srl, Via dell'Artigianato Z.I., 36020 Albettone (VI), tel. 0444790781, fax 0444790784, [email protected], www.isolgomma.com

Floor insulation Highmat Line TECHNICAL DATA Acoustic insulation for floating floors Strain (%) Note: maximum deflection (%) assessed on 1 sqm with a rubber insert equal to 5% of the surface. INSTALLATION INSTRUCTIONS Install the adhesive strip Profyle Flat to the wall and the Side Highmat along the whole perimeter. Apply a waterproof foil on the whole surface to protect the resilient layer. Install Highmat on the whole surface, staggered between two adjacent rows. Seal any gaps higher than 2 mm between panels, using the Stik tape. Install the reinforcement mesh (Ø 5 mm, net Apply the finishing...