Window, Sill, and Jamb Flashing WRAPTOR FLASH Wraptor Flash™ is a self-adhesive, self-sealing tape for flashing around windows and doors and for sealing building joints. The tough aluminized, multi-layer polymer film is coated with specially formulated rubberized asphalt. This aluminized film can be exposed to sun without effect for up to six months. Wraptor Flash™ features an easily removable silicone release paper to protect the adhesive surface. The adhesive is very aggressive and adheres to most clean, dry surfaces. Its waterproofing compound self-seals around punctures from nails, screws and staples. Wraptor Flash™ ties the window flange into the surrounding materials to protect the structures from water damage caused by blowing rain, snow and ice. It increases energy efficiency, bars insects from entry and reduces noise transmission to the interior of the structure. INTENDED USES Use Wraptor Flash™ to flash around windows and doors in new construction and in replacement installations. Wraptor Flash™ may be used to seal joints, around vents and other openings under most exterior surfaces including brick, stucco, wood, vinyl or metal siding. Recommended for installation directly to the sheathing underneath Wraptor Plus™ Reflective House Wrap. INSTALLATION HINTS · · · · · Install Wraptor Flash™ underneath house wrap directly to the sheathing. Surface must be clean, dry and free from oil and grease. Apply in clear weather at recommended temperatures. See temperature guide below. Apply uniform pressure by rolling the surface with hand roller. Use spray adhesive for marginal temperature and conditions. If temperature or substrate is questionable, prime as necessary with spray adhesive. Test for adhesion before continuing. Always use spray adhesive when applying Wraptor Flash™ to concrete, masonry or Dens-Glass. Products such as 3M™ Spray Adhesive Hi-Tack 76 may be used. Please read and follow manufacturer’s instructions. · Minimum Installation Temperature: 50°F (10°C) · Minimum Installation Temperature with Spray Adhesive: 35°F (1°C) CAUTIONS · Do not install over solvent-based sealants unless fully cured and dry to touch. · Do not tape the sill flange of the window to the sheathing. · Wraptor Flash™ should not be installed over flexible vinyl gaskets. (It may be installed with vinyl windows that have rigid flanges) Toll Free: 866.698.6562 www.insulationsolutions.com

Window Flashing Instructions 4: HEAD FLASHING DETAIL 1: INSTALLATION OF WINDOW SILL FLASHING Wood Sheathing and/or Insulation Board Rough Opening Wraptor FlashTM Wraptor FlashTM (extend beyond jamb flashing) Wraptor Flash 5: INSTALLATION OF WRAPTOR PLUSTM 2: INSTALLATION OF WINDOW Wraptor PlusTM Reflective House Wrap Apply Sealant Install Window Wraptor PlusTM (overlapped at seam) 6: INSTALLATION OF TAPE AROUND WINDOW 3: JAMB FLASHING DETAIL Wraptor FlashTM (overlaps window flange) Wraptor PlusTM Reflective House Wrap Window Frame Wraptor FlashTM (overlaps sill flashing) Wraptor FlashTM Toll...