Catalogs >
InSinkErator >
F-2000S Filtration System Plus

F-2000S Filtration System Plus
1Pages

Catalog excerpts

erator Instant Hot Water Dispensers Model F-2000S Filtration System Plus The Next Necessity A water filtration system exclusively designed for InSinkErator instant hot water dispensers Submittal Sheet • Reduces particulates, chlorine taste and odor, plus cysts, lead, mercury, asbestos, benzene, atrazine, 2,4-D, Lindane, Carbofuran and p-Dichlorobenzene for healthier, safer water • Quick-connect fittings guarantee easy installation • Sanitary, quick-change filter cartridge makes replacement easy. A simple twist is all it takes! • Automatically shuts off water when filter cartridge is replaced • Replace every 6 months at the rated capacity or if a noticeable reduction in flow rate occurs Specifications Filter Capacity Warranty: 1-year parts and in-home service*(excluding replaceable filter cartridge) * The complete InSinkErator warranty is included in the Care & Use booklet packed with each unit. F-2000S Chemical & Mechanical Reduction Filter Specifications: This cartridge provides mechanical and chemical reduction of dirt/rust, chlorine/taste/odor, particulates, cysts, asbestos, lead, mercury, lindane, benzene, carbofuran, p-dichlorobenzene, 2,4-D and Atrazine. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI Standards 42 and 53. Pressure: 30 -120 psi Temperature: 33-100°F Flow rate: .75 gpm Capacity: 500 gallons Tested & Certified by NSF International against NSF/ANSI Standard 42 and Standard 53 in the following InSinkErator Systems Only: GN1100, HC1100,GN2200, HC2200, GN2215, HC2215, H3300 or HC3300 for the reduction of claims specified on the Performance Data Sheet. REPLACEMENT ELEMENT Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under standard laboratory conditions, actual performance may vary. For cold water use only. Systems must be installed and operated in accordance with the Manufacturer's recommended procedures and guidelines. See warranty card for warranty. For service and parts, contact your local dealer or InSinkErator® directly at 1-800-558-5700. Contaminant Reduction * Based on the use of Cryptosporidium parvum oocysts NSF is a trademark of NSF International. Application guidelines/Water Supply Parameters for NSF Testing: Service flow of .75 gpm, community or private well water supply, water pressure of 30-120 psi, water temperature of 33°F-100°F. Except as noted, all testing performed at pH = 7.5 ± 0.5, Flow: .75 gpm, Pressure: 60 psi, Temp: 20° ± 3°C. Contact an authorized InSinkErator service agent for repairs or replacement components. Commercial & Residential Solutions The Emerson logo is a trademark and a service mark of Emerson Electric Co. InSinkErator may make improvements and/or changes in the specifications at any time, in its sole discretion, without notice or obligation and further reserves the right to change or discontinue models. ©2013 InSinkErator, a business unit of Emerson Electric Co. All Rights Reserved.

Open the catalog to page 1