Catalogs >
InSinkErator >
F-1000 Replacement Filter

F-1000 Replacement Filter
1Pages

Catalog excerpts

Instant Hot Water Dispensers The Next Necessity Model F-1000 Replacement Filter For cleaner, fresher-tasting water Submittal Sheet • Includes 1 replacement filter for use with InSinkErator water filtration system • Reduces particulates, chlorine taste and odor for clean, refreshing taste • Sanitary, quick-change filter cartridge makes replacement easy. A simple twist is all it takes! • Replace every 6 months at the rated capacity or if a noticeable reduction in flow rate occurs Specifications Filter Capacity F-1000 Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications: This cartridge provides mechanical and chemical reduction of chlorine taste & odor and particulate class III. Dimensions Tested & Certified by NSF International against NSF/ANSI Standard 42 in the following InSinkErator Systems Only: GN1100, HC1100, GN2200, HC2200, GN2215, HC2215, H3300 or HC3300 for the reduction of claims specified on the Performance Data Sheet. For systems using two handle HC model faucets, operate only one handle at a time. Pressure: 30-120 (207-827 kPa) psi Temperature: 33°F - 100°F Flow Rate: .75 gpm Capacity: 500 gallons Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Do not use with water that is micnobiologically unsafe or of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty card for warranty. For service and parts, contact your local dealer or InSinkErator® directly at 1-800-558-5700. Contaminant Reduction Application guidelines/Water Supply Parameters for NSF Testing: Service flow of .75 gpm, community or private well water supply, water pressure of 20-120 psi (138-827 kPa), water temperature of 33°F-100°F Except as noted, all testing performed at pH = 7.5 ± 0.5, Flow: .75 gpm, P ressure: 60 psi, Temp: 20°±3°C. Refer to the Performance Data Sheet for InSinkErator Filter System Model F-2000S Replacement Cartridge: F-2000 Contact an authorized InSinkErator service agent for repairs or replacement components. Replacement filters F-1000 and F-2000 can be ordered by calling 800-558-5700, visiting shop.insinkerator.com, or by contacting an authorized InSinkErator reseller. 4 EMERSON. Commercial & Residential Solutions The Emerson logo is a trademark and a service mark of Emerson Electric Co. InSinkErator may make improvements and/or changes in the specifications at any time, in its sole discretion, without notice or obligation and further reserves the right to change or discontinue models. ©2013 InSinkErator, a business unit of Emerson Electric Co. All Rights Reserved.

Open the catalog to page 1