EN - CLADDING ANCHORS
4Pages

GENERAL CATALOGUE CLADDING ANCHORS GENERAL CATALOGUE Start Clamp CLADDING ANCHORS Intermediate Clamp Material: Stainless steel. 316 AISI Model weight 10: 4,70 gr. Model weight 15: 5,15 gr. Anchoring with a tab to fasten the slabs, recommended to start and end an installation. Two models with different measurements to carry out exposed or hidden assemblies, depending on the slab thickness. They work as an additional safety measure to prevent the risk of detachment. The INTERMEDIATE 10 Material: Stainless steel. 316 AISI Model weight 10: 7,8 gr. Model weight 15: 8,15 gr. Anchor with double tab to fasten the top and bottom slabs. Two models with different measurements to carry out exposed or hidden assemblies, depending on the slab thickness. They work as an additional safety measure to prevent the risk of detachment. The separation joint between separation joint between slabs should not be made using the thickness of crossheads for proper installation. INTERMEDIATE CLAMP 15 TYPE B INTERMEDIATE CLAMP 10 TYPE B START CLAMP 15 TYPE A START CLAMP 10 TYPE A *Minimum joint recomended 5 mm (UNE 138002:2017) UNE-EN 10088-2: Technical stainless steel for corrosion resistant steel sheets and strips used for general purposes. Both models can be installed as exposed or hidden depending on the thickness of the tile. *Minimum joint recomended 5 mm (UNE 138002:2017). UNE-EN 10088-2: Technical stainless steel for corrosion resistant steel sheets and strips used for general purposes. Both models can be installed as exposed or hidden depending on the thickness of the tile. Start Clamp 15 mm TYPE A slabs should not be made using the thickness of the anchors, but with tiling the anchors, but with tiling crossheads for proper installation. Start Clamp 10 mm TYPE A Intermediate Clamp 15 mm TYPE B Intermediate Clamp 10 mm TYPE B

GENERAL CATALOGUE CLADDING ANCHORS GENERAL CATALOGUE Omega Clamp CLADDING ANCHORS Material: Stainless steel A2 OMEGA 10 Material: Stainless steel AISI 316 Model weight 10: 1,90 gr. Model weight 15: 2,40 gr. Mechanical fastening anchors are necessary as an additional safety measure against the risk of falling. The separation joint between slabs should not be made using the thickness of the anchors, but with tiling Nylon plug crossheads for proper installation. Resistance Kg Hollow brick Solid brick Material: Nylon Suitable for hollow and solid supports (stone, brick, concrete, etc)....

GENERAL CATALOGUE CLADDING ANCHORS GENERAL CATALOGUE CLADDING ANCHORS The placement method of our clamps is exactly the same for the EXPOSED and HIDDEN models. Start Clamp and Intermediate Clamp Assembly anchoring with a hidden system manufactured with 3mm diameter stainless steel rod. Mechanical fastening anchors are necessary as an additional safety measure against the risk of falling. The separation joint between slabs should not be made using the thickness of the anchors, but with tiling crossheads for proper installation 1. Measure and assemble the start anchors 2. Glue the part and...

GENERAL CATALOGUE CLADDING ANCHORS Establish the resistance to the horizontal and vertical force of anchoring clamps in the cladding façade. MATERIALS CLADDING ANCHORS Stainless steel The stainless steel is prepared by adding chrome to the ordinary steel, which provides a greater resistance to the impact of water and air. Some of its properties is the resistance to corrosion and heat. ALL our façade anchors are made with STAINLESS steel, so their durability is almost endless under any working condition. Considering that the anchors have to guarantee the safety and resist heavy loads, a...