Technical Specifications Roller Curtain The shutter curtain is constructed from cold rolled galvanised concave steel laths (76mm x 22swg). Other gauges may be supplied depending on the shutter width. Each lath is retained by pressed steel or nylon end locks fixed with galvanised steel rivets. Bottom Rail A rigid inverted L or T section bottom rail, formed from a cold rolled galvanised section. Roller Barrel Constructed from mild steel tube of suitable outside diameter and wall thickness to suit the shutter application. The barrel encases the 240 volt tubular motor. The main body of the motor is fixed to the door bracket plate and the outer body rotates the barrel, opening and closing the door. Operation The motors are 240 volts and are encased in the roller tube. Motors can be supplied with or without an emergency hand crank facility. Normal operation is by paddle switch or keyswitch. Remote control is via key fob type transmitter. Power Requirement A single phase 13 amp 3 pin plug socket is required (within 1m of each door opening) for each tube motor installation. For multiple installations, group controllers can be supplied. Finish Side guides, support angles and door curtains come galvanised as standard. Powder Coated and Plastisol finishareavailableat additionalcost. Coil Casing (Hoods) and Fascias Coil casings or fascias can be supplied at additional cost and are supplied galvanised as standard unless specified otherwise. Perforated Laths Perforated Laths can be supplied at additional cost and are supplied galvanised as standard unless specified otherwise. Weight Approximately 35kg per M2 Head Office Industrial Door Engineering Winnington Avenue Northwich Cheshire CW8 4EQ Web www.industrial-door-eng.co.uk Email [email protected] Tel 01606 563045 Fax 01606 871482 Covering North and Mid Wales, The Midlands, The North West and Yorkshire