1. Catalogs
  2. Indiana Limestone Company
  3. FINISHED GOODS & LANDSCAPE MATERIALS:Caps

FINISHED GOODS & LANDSCAPE MATERIALS:Caps
1 /1Page

FINISHED GOODS & LANDSCAPE MATERIALS:Caps

FINISHED GOODS & LANDSCAPE MATERIALS:Caps
1 /1Page

Catalog excerpts

FINISHED GOODS & LANDSCAPE MATERIALS:Caps-1

Pier Cap Installation and Technical Information Pier Cap Installation and Technical Guide Delivery, Storage, and Handling Indiana Limestone Company (ILC) Pier Caps should be unloaded and handled carefully to prevent excess breakage. Product will be supplied adequately packaged on pallets or timbers to keep finished stone clear of the ground. Storage area should be a well-drained space graveled or chipped for protection against mud splatters. Product should be handled carefully to avoid excess chips and scratches. When using pry bars to move stone into place, use padding to protect the edges of the stone. Rock Face Setting Mortar Use of Type N Masonry Cement is highly recommended for the setting bed cement mix. White Cement does not contain the chemicals that when activated by water can cause unsightly staining. Typical fine sand will be adequate for the cement mix. A setting bed depth of 1” to 1-1/2” is recommended. Pointing of Joints Grouting or Pointing of the joints can be done with the same Type N White Masonry Cement (mixed with White Sand to allow for accurate coloring). For an even more water repellent joint the use of a Urethane/ Polyurethane sealant is recommended. Anchors Typical mortar set installation does not require any additional anchoring. However, if additional anchoring is required or desired based on design specifications, stainless steel dowels (smooth or threaded), or stainless steel dowels with straps are both commonly used for the attachment of limestone pier caps. Square Edge Height Depth Length Pcs Per Pallet To order or for Dealer information call Rock Face Square Edge Rock Face Square Edge Rock Face Square Edge Rock Face Square Edge Rock Face Square Edge Physical Characteristics, Performance Table Indiana Limestone complies with the requirements of ASTM C-568, Type II, Medium density limestone. Square Edge Cleaning After mortar has set, the pier caps should be brushed down with a stiff fiber brush, then carefully rinsed with clear water to remove any accumulation of stain or matter foreign to the limestone. Rock Face

 Open the catalog to page 1
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.