PLASTUK LEGNO 3005.Polyester filler paste for wood 13/12/13 LRD/nz : see colours card : paste code 40001015 (tube), code 40011015 (cartridge). : 100 parts of “A” + 2 + 3 of “B” by weight with tube; DIDOC apparatus: fixed position. : 5 + 7 minutes with 3 parts by weight of hardener code 40011015 to 100 parts of “A” : after 2 hours : after 45 minutes on medium thickness : very good : 12 months in original sealed container, away from light. Description and use Two-pack filler paste, easy to work, based on unsaturated polyester resins, suitable to carry out works on wooden surfaces, like the reconstruction of defective parts even of big dimensions, fillings, trimmings, etc. It’s possible to obtain any final thickness applying several layers allowing few minutes between them. It gets quickly hard by adding the proper catalyst. After hardened it can be sawed, planed, drilled, and sanded the same as a piece of wood. It can be repainted with most of the enamels and stains available on the market. Technical data Colour Specific gravity** Hardener Curing ratio Gel time** Complete polymerisation** Sandability** Shrinkage Flexibility Water resistance Solvent resistance TVOC emissions Storage life** **Data recorded @ 20°C (68°F.) Application note Types of surface : Woods of every type provided they are treated as suggested in the following “Surface preparation”. For any further information, apply to our TECHNICAL SERVICE. Surface preparation : Surface must be dry, free of dust, earth, fouling, rot, aged paints and wax. Wood must be compact with high mechanical resistance and with humidity within 8% and 15%. “Hairy” surfaces (wood fibers perpendicularly cut) have to be well imbued with a primer in order to strengthen the mass. Cerous essences such as exotic wood, birch tree, or oily as olive tree, tek or with a high content of natural resins as fir, larch, pine, and other coniferae must be IMPA Spa - Via Crevada 9/E - 31020 San Pietro di Feletto (TV) Italy - tel. +39 0438 4548 - fax 0438 454915 - www.impa.it - [email protected]

13/12/13 LRD/nz well cleaned with a proper solvent and, besides, they have to be insulated with a special primer. Palisander (rosewood), oak, chestnut tree an others that contain substances which make difficult the adhesion, or soaked ancient woods of coal-tar, linseed oil, smokes, etc. must be treated anyhow with one or more coats of a primer surfacer (insulating). In case of surfaces old and particularly difficult to be cleaned, it is suggested a sand-blasting followed by an impregnating-insulating treatment. The wood treated with insecticides and phenol-based compounds must be carefully insulated...

PLASTUK LEGNO Polyester filler paste for wood 13/12/13 Cleaning Clean equipment immediately after use with cellulose thinner. NOTE: Avoid to apply when temperature is below + 10°C (50°F.) Information provided in this technical data sheet is based upon our best experience and technical knowledge; it does not absolve the users from carrying out tests and preventive checks in order to verify the suitability for use. For further technical information about specific systems and/or special applications, please contact our TECHNICAL SERVICE. FOR PROFESSIONAL USE ONLY This note replaces all the previous...