COLD GOLDTM Cold-Applied Roofing System Application Booklet • Solvent-Free • VOC-Free • Non-Hazardous • Moisture-Cured • Good Initial Bond www.iko.com

Products IKO COLD GOLDTM Field Adhesive (Single Component) · To be used on the field only (horizontal surfaces 1/12 or 8% slope maximum.) For greater slopes, use Flashing Cement. IKO COLD GOLDTM Flashing cement (Two Part - A & B) · To be used on flashing (vertical and horizontal surfaces). Required Tools · 3/16” V-Notched Hand Trowel · Hand Roller (Flashing Cement) · T-Square · 3/32” V-Notched Hand Trowel/ · Chalk Line Squeegee (Field Adhesive) · Mineral Spirits · Steel Floor Roller (Min.75#- (for cleaning tools) Max 100#) · Broom · 1/2” Power Drill (9 AMP) · Roofing Knife c/w Paint Mixer 2 Cold...

Mixing (for all applications) · Mix product thoroughly with electric drill and paint mixer no less than 3 minutes, but no more than 4 minutes. Insulation – Ribbon Application Firmly embed insulation in IKO Cold GoldTM Adhesive using 1/2” ribbons with subsequent ribbons running 12” on centre, parallel to top of steel deck flutes or “S” pattern on non-metal decks. (approx. 1,000 sq. ft. per 18.7 L) Cold Applied Roofing Systems 3

FIELD ADHESIVE 3/32” V-notched 5 GALLON (18.7 L) PAIL trowel/Squeegee · Apply evenly using a 3/32” V-Notched trowel/ squeegee. · Trowel must be perfectly vertical. · DO NOT APPLY THICKER THAN DIRECTED. Protectoboard - rIBBON Application Firmly embed Protectoboard in IKO Cold GoldTM Adhesive using 1/2” ribbons with subsequent ribbons running 12” on centre, or “S” pattern on non-metal decks. (approx. 1,000 sq. ft. per 18.7 L) 4 Cold GoldTM

Field Membrane Application - Membranes Used field · Modiflex MF-95-SS-Base (147 sq. ft./roll) (Fiberglass reinforcement mat) · Modiflex Cold GoldTM Base (147 sq. ft./roll) (Polyester reinforcement mat) · Modiflex MP-180-Cap (98 sq. ft./roll) · Modiflex Prevent MP-180-Cap (Class A) (98 sq. ft./roll) FLASHINGs · Modiflex Cold GoldTM Base (147 sq. ft./ roll) (Polyester reinforcement mat) · Modiflex MP-180-Cap (98 sq. ft./roll) · Modiflex Prevent MP-180-Cap (Class A) (98 sq. ft./roll) Rolling Rolling · Roll membrane using a 75 lb. to 100 lb. roller. · Ensure rolling is performed from centre of sheet...

Flashing Cement 3/16” V-notched trowel · Mix Part A & B – no less than 3 minutes but no more than 4 minutes. · Fully adhere in IKO Cold GoldTM Flashing Cement using 3/16” V-Notched trowel (coverage approximately 80 sq. ft per 7.5 L). · Ensure proper adhesive application; excessive adhesive may cause longer cure time. · Ensure proper adhesion by using a hand roller over the entire area. · Apply Flashing Cement to all inside and outside corners to form a liquid gusset. · Coat substrate only. · At room temperature, pot life will be approximately 90 minutes. IKO COLD GOLD™ FLASHING CEMENT Used for...

FLASHING CEMENT MIX PART A & B HAND ROLL IKO STANDARD FLASHING DETAIL ■ Minimum flashing height is 8" (203 mm) above the roof surface Base flashing 8" (203 mm) minimum past toe of cant strip and 1" (25 mm) less the height of cap flashing Maximum past toe of cant strip Base Sheet (Field) Cold Applied Roofing Systems

Advantages Features & Benefits · Solvent-Free: No pungent odors · Compatible with IKOTherm, and no fire hazard. Protectoboard and Modiflex Base/ · VOC-Free: No volatile compounds. Cap sheets, Modified Vapor · Non-Hazardous: Unrestricted Protector, Expanded polystyrene/ transport in North America. Extruded polystyrene. · Moisture-Cured: No solvents to · Substantial cure time in 48 hours “flash off” with a fast cure time. under ideal conditions. · Wide range of application temperatures: -10°C (14°F) to 40°C (104°F).* · Easy to apply (notched squeegee) and easy to clean up (mineral spirits). · NO...

Installation tips Don’t Forget To: · Relax membrane prior to use. · Back-roll membrane to ensure full bond. · Keep product warm until ready for use. · Use a 9 amp (minimum) drill for mixing. · Clean tools with mineral spirits. · Roll all materials after they are installed. · Ensure proper mixing no less than 3 minutes, but no more than 4 minutes. · Use the right size trowel: - 3/16” Flashings - 3/32” Field · Train all applicators. · Use the right amount of Cold GoldTM – too much material is not good! Cold Applied Roofing Systems 9

Thank you for considering IKO Premium Roofing products. For additional information on IKO’s full line of superior Commercial/Industrial Roofing and Waterproofing products please call: 1-888-766-2468, or visit our web site at: www.iko.com Note: The physical properties of the products described in this catalogue represent average typical results obtained by testing our products according to accepted industry test methods. These values are subject to normal manufacturing variations, and are supplied as a technical guideline only; they may be subject to change without notice. Current product specifications...