Hanging instructions 1/3 21500 - 21506 gatsby After removing the old wallpaper, the substrate must be clean, dry, firm, slightly absorbent and even. Any light-coloured non-woven wallpaper also requires a uniform and light-coloured substrate. If the colour of the substrate differs greatly from the colour of the wallpaper, it is recommended to first apply primer to the wall. This primer must be the same shade as the wallpaper. Rub off old coats of paint, and wash down the wall using water and degreaser. The walls must be non-alkaline. If they are not, they must be cleaned and treated with a suitable fixing agent. Ensure that this agent is able to penetrate the substrate. Also treat walls that are too absorbent or powdery (including HANGING INSTRUCTIONS PURE IMPULSE plaster walls) using a suitable fixing agent. Only apply wallpaper to walls which are completely dry, otherwise discoloration and loss of adhesion will occur. 2. ADHESIVE Adhesive for non-woven wallpaper like Arte Clearpro, or Metyl Special (200 grammes in 4 litres of water) with the addition of 20% PVA adhesive. 3. HANGING Check the product for faults before hanging it and check the result for faults after hanging 3 strips of wallpaper. If any errors are visible, stop the work and contact the manufacturer. Only hang rolls with the same batch number next to each other. Avoid creases and handle with care at all times. Cut the strips of wallpaper to the correct length. Apply the glue evenly on the wall with a microfibre roller of 12 mm (always apply adhesive slightly further than the width of the strip). Roll up the strip and place the dry top against the pasted wall. Then place the strip against the top of the pasted wall and unroll the strip down to the bottom of the wall. First position the start of the seam, then rub outwards from the seam across the width of the strip. Use a soft rubber roller to make the strip smooth and even. DO NOT USE A SPATULA. Use a seam roller on the seams. Using a sharp knife and a ruler, carefully cut the surplus wallpaper from the top and bottom. Using a damp sponge, immediately remove any adhesive stains before it dries. Do this after hanging each strip. Finish papering a complete wall before starting to paper the next. PURE IMPULSE

Hanging instructions 2/3 21530 - 21534 gravity After removing the old wallpaper, the substrate must be clean, dry, firm, slightly absorbent and even. Any light-coloured non-woven wallpaper also requires a uniform and light-coloured substrate. If the colour of the substrate differs greatly from the colour of the wallpaper, it is recommended to first apply primer to the wall. This primer must be the same shade as the wallpaper. Rub off old coats of paint, and wash down the wall using water and degreaser. The walls must be non-alkaline. If they are not, they must be cleaned and treated with a suitable...

Beautiful wallpapers from