155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] QUICK-CONNECT INSTRUCTIONS 1. Once the LICHTSTAR canopy has been installed, the quick-connect feature 2. Be sure to discard the nut (A) removed from the canopy and universal backplate assembly, referred to in Step 2 under the Mounting Instructions. This will allow access to the threaded stem (G) at the 3. Insert the plug (E), located at the end of the cable or reflector, into the center of 4. Slide the finished stem (D) over the plug (E) and screw into place on the threaded Diagram shows Canopy C-8120 with a cable assembly. Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. LICHTSTAR Triple & Quad Canopy CARE INSTRUCTIONS Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp. Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

e-mail: [email protected] MOUNTING INSTRUCTIONS Please note: if a dimmer is required, it is recommended that a Lutron ELV (Electronic Low Voltage) dimmer be used. It is recommended that this fixture be installed and hung by a licensed electrician. 1. Disconnect the power to the outlet box before servicing. crossbar strap (C), allowing access to the crossbar strap 3. Connect the wires from the generally accepted electrical 4. Screw the crossbar strap (C) to the outlet box. For item C-8410 Quad Diamond, locate the curved cut-outs in the backplate and install screws at each location...

155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] BULB REPLACEMENT INSTRUCTIONS 1. Disconnect the power to the outlet box before servicing. 2. Unscrew the reflector (A) counterclockwise and remove with the defective bulb. 3. Screw the reflector (A) back onto the fixture. 4. Install a new bulb (B): 35 Watt/12Volt, Osram Decostar, GU 5.3 QUICK-CONNECT INSTRUCTIONS Once the LICHTSTAR canopy has been installed, the quick-connect feature Be sure to discard the nut (A) removed from the canopy and universal backplate assembly, referred to in Step 2 under the...