155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] CAUTION, IMPORTANT SAFETY INSTRUCTIONS This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electrical shock. This plug will fit a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug. INSTRUCTIONS PERTAININGTO A RISKOF FIRE, ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION OR WARNING ■ To reduce the risk of FIRE, ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION OR 1. Turn off power/unplug and allow to cool before replacing bulb. 2. Bulb gets HOT quickly. Contact only switch/plug when turning on. 3. Do not touch hot lens, guard or enclosure. 4. Do not remain in light if skin feels warm. 5. Do not look directly at lighted lamp. 6. Keep lamp away from materials that burn. 7. Use only with a 100 Watt, bayonet base halogen bulb or smaller bulb. 8. Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb. 9. Do not operate the portable luminaire with a missing or damaged guard, lamp containment SAVE THESE INSTRUCTIONS Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Halogen Swing-Arm Floor Lamp Please make sure that the following parts for your lamp are enclosed: A. Metal reflector (9424/1 ) or Glass reflector (9434/1 ) B. Frosted glass shield C. Bayonet base halogen bulb made by Osram in Germany (100 Watts) D. Dimmer knob and stem Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

e-mail: [email protected] Installation Instructions 1. Insert the bulb into the bayonet socket. The bulb is inserted by pushing it slightly down into the socket and then turning it clockwise. NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH YOUR BARE HANDS. 2. Set the glass shield (B) on the grooved counterpart of the reflector (A). 3. Screw the reflector onto the base. Holding the reflector with one hand, and the glass shield with the other hand, place the reflector and glass shield over the bulb and onto the base. Turn the reflector clockwise until it is completely assembled. 4. Lower...