155 Hardman Avenue South, South St. Paul, MN 55075 e-mail: [email protected] Shorten the Support Cord_ (G) by unscrewing it from its base. 2. Loosen the screws (O) with the 1.5 mm alien wrench (N) to release the support 3. Pull the cable (P) to the desired length. 4. Secure the screws (O) with the alien back into place on the base. Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH. Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Care Instructions Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp. Holtkötter® and Holtkötter Leuchten® are registered trademarks of Holtkötter International, Inc. All Rights Reserved.

Please make sure that the following parts for your fixture are enclosed: 4. Black plastic wrench 5. Osram GU5.3.12 Volt / 35 Watt Decostar ECO (1 each] IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN INSTALL THIS FIXTURE. Installation (See Diagram on back) Disconnect the power to the outlet box. 2. Remove the crossbar strap (A) from the canopy (D) by loosening the set screw (F) from the canopy (D) using 3. Mount the crossbar strap (A) to the outlet box. 4. Connect the wires from the pendant with the wires in the outlet box according to generally accepted electrical standards. 5. Slide canopy...